Question is ⇒ Which of the following diode is designed to operate in the breakdown region?, Options are ⇒ (A) Signal diode, (B) Power diode, (C) Zener diode, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following diode is designed to operate in the breakdown region?, Options are ⇒ (A) Signal diode, (B) Power diode, (C) Zener diode, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following diode is designed to operate in the breakdown region?
A.	Signal diode [Wrong Answer]
B.	Power diode [Wrong Answer]
C.	Zener diode [Correct Answer]
D.	None of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a trivalent impurity is added, the semiconductor becomes
p type
n type
intrinsic
neutral

⇒ In thermal ohm's law, temperature and power loss are analogous to
V and I respectively of ohm's law
I and V respectively of ohm's law
R and V respectively of ohm's law
I and R respectively of ohm's law

⇒ When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.
TRUE
FALSE

⇒ Which of these has semi-conductor metal junction?
PIN diode
Photo diode
Tunnel diode
Schottky diode

⇒ The relative stability of a system is given by
gain margin alone
phase margin alone
both phase and gain margins
either (a) or (b)

⇒ A 4 bit ripple counter starts in 0000 state. When the counter reads 0010 the number of clock pulses which have occurred is
2
18
2 or 18
2 or 18 or 34

⇒ In 8085, high level on INTR line can be recognised only if
TRAP and RST lines are high
TRAP and RST lines are not high
TRAP line is high but not RST line
RST line is high but not TRAP line

⇒ For formation of state equations, the inductors and current sources
should be in tree
should be in cotree
may be in tree or cotree
should be in both tree and cotree

⇒ Figure shows a portion of linear v - i characteristics of diode. If applied voltage is + 6 V, the current wil
42 mA
48 mA
51 mA
54 mA

⇒ The loss of charge method can be used to measure
resistance of shunt
insulation resistance of cable
resistance of shunt winding
both (b) and (c)

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ In standard TTL the totem pole stage refers to
multiemitter input stage
phase splitter
output buffer
open collector output stage

⇒ A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be
2.2 A
less than 2.2 A
2.2 A or less than 2.2 A
2.2 A or less or more than 2.2 A

⇒ Consider the program segment written for 8085 based sys
41
69
44
Indeterminate

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is
0°
90°
180°
either (a) or (c)

⇒ A characteristic property of crystal is its periodicity of structure.
TRUE
FALSE

⇒ Find 'X' in the circuit be
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15)
0
Σ(14)
1

⇒ A gate in which shift register is connected as shown in the figure below. How many clock pulse (after reset to '0') the contents of the shift register are '000' ag
3
6
16
8

⇒ In a common Emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche breakdown of Base emitter junction
collector to Base Breakdown voltage with emitter open (βV_CBO)
collector Emitter Breakdown voltage with base open (βV_CBO)
zener breakdown voltage of the emitter base Junction

⇒

Match the following:

	List I (Antenna)		List II (Communication system)
A.	Turnstile	1.	Radar
B.	Yagi	2.	TV transmission
C.	Dish	3.	MW broadcasting
D.	Vertical mast	4.	TV reception

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-2, B-4, C-3, D-1
A-4, B-2, C-1, D-3

⇒ In TV system in India IF video and IF audio frequencies are
33.4 and 28.4 MHz respectively
38.9 and 33.4 MHz respectively
43.8 and 38.9 MHz respectively
33.4 and 38.9 MHz respectively

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ What would be the rms value of a sine wave having the same peak value as that of the above mentioned periodic wave?
42.2 V
19 V
38.2 V
none

⇒ What does the B register contain after the first MOV B, A has been executed?
40 H
60 H
80 H
80 D

⇒

Assertion (A): Hamming code is commonly used for error correction

Reason (R): In Hamming code the number of parity bits increases as the number of information bits increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a picture tube, the video signal is applied to
cathode
grid
any anode
either cathode or grid

⇒ In a CRO, the frequency of output of time base generator
is only one constant value
is adjustable
varies automatically
either (a) or (c)

⇒ The given figure shows a K-map for a Boolean function. The number of essential prime implicant
4
5
6
8

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz