Question is ⇒ The minimum gate current which can turn on SCR is called :, Options are ⇒ (A) trigger current, (B) holding current, (C) junction current, (D) breakover current, (E) , Leave your comments or Download question paper.

Question is ⇒ The minimum gate current which can turn on SCR is called :, Options are ⇒ (A) trigger current, (B) holding current, (C) junction current, (D) breakover current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The minimum gate current which can turn on SCR is called :
A.	trigger current [Correct Answer]
B.	holding current [Wrong Answer]
C.	junction current [Wrong Answer]
D.	breakover current [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ How many lines are there in address bus of 8085 μp?
6
8
12
16

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒ VTM stands for voltage tunable magnetron.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Poles and zeros of lie an real axis driving point LC network	1.	lie an real axis
B.	Canonic LC network has	2.	a zero
C.	The number of Canonic networks for the given driving point function	3.	minimum number of elements
D.	The first critical frequency nearest the origin for RL driving point impedance	4.	four
		5.	minimum number of elements
		6.	alternate
		7.	either a pole or zero
		8.	three

A-1, B-5, C-8, D-7
A-6, B-5, C-3, D-2
A-1, B-5, C-4, D-2
A-1, B-3, C-4, D-7

⇒ An RLC series circuit is underdamped. To make it overdamped, the value of R
has to be increased
has to be decreased
has to be increased to infinity
has to be reduced to zero

⇒ De Sauty bridge is very widely used due to
simplicity
perfect balance for imperfect capacitor
perfect balance for air capacitors
maximum sensitivity

⇒ The addition of n type impurity to intrinsic material creates allowable energy levels.
slightly below conduction band
slightly above conduction band
slightly below valence band
slightly above valence band

⇒ An arithmetic statement in C must be
integer mode arithmetic statement
real mode arithmetic statement
mixed mode arithmetic statement
any of the above

⇒ A geosynchronous satellite
has the same period a that of the Earth
has a circular orbit
rotates in the equatorial plane
has all of the above

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒ Noise which assumes great importance at high frequencies is
flicker noise
Johnson noise
transit-time noise
shot noise

⇒

Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If E_b is the potential of accelerating anode, the energy of electrons as they emerge from electron gun is proportional to
E_b
E_b
E_b^1.5
E_b²

⇒ In 8085 microprocessor, what is the length of temporary register?
6 bits
8 bits
12 bits
16 bits

⇒ An input voltage V(t) = 10 2 cos (t + 10°) + 10 3 cos (2t + 10°)V is applied to a series combination of resistance R = 1 kΩ inductance L = 1H. The resulting steady-state current i(t) in ampere is
10 cos (t + 55°) + 10 cos (2t + 10° tan^-12)
10 cos (t + 55°) + 103/2 cos (2t + 55°)
10 cos (t - 35) + 10 cos (2t + 10° - tan^-12)
10 cos (t - 35) + 103/2 cos (2t + 35°)

⇒ A waveguide section in a microwave circuit acts as
LP filter
Bandpass filter
HP filter
Band stop filter

⇒ An antenna having a high Q has
lower BW
higher BW
flat response
none of the above

⇒

Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ In direct addressing mode of 8085
All instructions are 3 bytes long
All instructions are 3 bytes long except IN instruction which is 2 bytes long
All instructions are 3 bytes long except IN and OUT instructions which are 2 bytes long
All instructions are 2 bytes long

⇒ The symbol in figure is
UJT
PUT
SCS
SBS

⇒ The function Y = A B C + AB C + A B C + A BC is to be realized using discrete gates. The inputs available are A, B, C. We need a total of
8 gates
6 gates
10 gates
5 gates

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ Fermi level is the maximum energy that an electron can possess at 0 K.
TRUE
FALSE

⇒ The chemical effect of current is used in
dc ampere hour meter
dc ammeter
ac energy meter
all of the above

⇒ Compact discs use
magnetic recording and retrieval
optical recording and retrieval
optical recording but magnetic retrieval
magnetic recording but optical retrieval

⇒ The sum S of A and B in a Half Adder can be implemented by using K NAND gates. The value of K is
3
4
5
none of these

⇒ To measure an unknown ac voltage by an ac potentiometer it is desirable that supply for the potentiometer is taken
from a battery
from a source which is not the same as unknown voltage
from the same source as the unknown voltage
either (a) or (b)

⇒ A chopper is a high efficiency circuit.
TRUE
FALSE

⇒ If σ is standard deviation, variation is
σ - 1
σ^1.5
σ²
σ³