Question is ⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is, Options are ⇒ (A) r = λh, (B) r = λh2, (C) λ = rh, (D) h = λr, (E) , Leave your comments or Download question paper.

Question is ⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is, Options are ⇒ (A) r = λh, (B) r = λh2, (C) λ = rh, (D) h = λr, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
A.	r = λh [Correct Answer]
B.	r = λh² [Wrong Answer]
C.	λ = rh [Wrong Answer]
D.	h = λr [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Fermi-Dirac statistics, the probability of electron occupation of an energy level equal to Fermi level is
0
0.25
0.5
1

⇒ In a resistance loaded amplifier, the gain decreases at high frequencies because
decreasing reactance of the stray C_T
increasing reactance of the stray C_T
increasing reactance of C_T
decreasing reactance of C_T

⇒ In decimal system the base of radix is
0
1
10
e

⇒ Short-circuited stubs are used, because open-circuited stubs are
liable to radiate
complex in nature
providing open-circuit environments
unable to provide work over large frequency range

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ The digit F in hexadecimal system is equivalent to number __________ in decimal system.
16
15
17
8

⇒ For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
1000 MHz
5000 MHz
14000 MHz
140000 MHz

⇒

Assertion (A): Relative permittivity is determined by the atomic structure of the material.

Reason (R): Absolute permittivity is determined by the atomic structure of the material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ Consider the following statements:

A flip-flop is used to store 1-bit of information.
Race-around condition occurs in a J-K flip-flop when both the inputs are 1.
Master-slave configuration is used in flip-flops to store 2-bits of information
A transparent latch consists of a D-type flip-flop.

Which of the above statements is/are correct?
1 only
1, 3 and 4
1, 2 and 4
2 and 3 only

⇒ For TV broadcast, picture signal is modulated in
SSB
VSB
FM
AM

⇒ A coil of resistance R and inductance L is connected in series with 5 μF capacitor. The source frequency is equal to resonance frequency and circuit current is 0.5 A. Another 5 F capacitor is connected in parallel with the above capacitor. The circuit current will be
0.5 A
more than 0.5 A
less than 0.5 A
0.5 A or less

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ The integral of unit step function is a ramp of slope unity.
TRUE
FALSE

⇒ In liquids charge carriers are electrons only.
TRUE
FALSE

⇒ To couple a coaxial line to a parallel to wire line it is best to use a
slotted line
balun
directional coupler
quarter wave transformer

⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
30 and 24 MHz
27.3 and 26.7 MHz
27.3 and 26.97 MHz
27.3 and 26.97 MHz

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ Which of the following operations will give the result 2 in C?
42857
4.0 / 2
4.0 / 2.0
4 / 2.0

⇒ For a FM wave carrier modulating frequency is 10 kHz and bandwidth is 2 MHz. If the modulating signal amplitude is doubled, the bandwidth will be
0.5 MHz
1 MHz
2 MHz
4 MHz

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ In the given figure the reflected voltage wave after first reflectio
18 V
-18 V
30 V
-30 V

⇒ Consider the following statements as regards pulse repetition frequency

Pulse interval should be as large as possible so that a pulse returns before next pulse is transmitted
Greater the number of pulses reflected from a target, greater is the probability of distinguishing it from the noise

Which of the above are correct?
1 only
2 only
both 1 and 2
neither 1 nor 2

⇒ The coupling capacitor in amplifier circuits
affects dc biasing
does not affect dc biasing
affects dc biasing to some extent
both (a) and (c)

⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
becomes zero
abruptly decrease
abruptly increases
remains constant

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ The number of channels in a stereophonic system is
8
4
2
1

⇒ MOS circuits as compared to bipolar circuits take
more chip area
less chip area
same chip area
none of these