Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A sine wave of voltage varies from zero to maximum of 200 V. How much is the voltage at the instant of 30° of the cycle ? |

A. | 50V [Wrong Answer] |

B. | 82.8V [Wrong Answer] |

C. | 100V [Correct Answer] |

D. | 173.2 V [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :Pradeep Said on 2017-10-24 10:46:42200 sin 30 Ayyanagouda Said on 2017-03-08 19:57:03How Virendra Said on 2016-11-09 11:43:44ans is B !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The transient currents are associated with the

Changes in the stored energy in the inductors and capacitors

Impedance of the current

Applied voltage to the circuit

Resistance of the circuit

⇒ Ohm is the unit of all of the following except

Inductive reactance

Capacitive reactance

Resistance

Capacitance

⇒ In a pure resistive circuit

Current lags behind the voltage by 90°

Current leads the voltage by 90°

Current can lead or lag the voltage by 90°

Current is in phase with the voltage

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates

Low efficiency

High power factor

Unity power factor

Maximum Load current

⇒ The safest value of current the human body can carry for more than 3 second is

4 mA

9 mA

15 mA

25 mA

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.

Impedance

Susceptance

Quality factor

Selectivity

⇒ The power taken by a 3-Φ load is given by the expression

√3 V

_{L}I

_{L}sinΦ

√3 V

_{L}I

_{L}cosΦ

3 V

_{L}I

_{L}sinΦ

3 V

_{L}I

_{L}cosΦ

⇒ In a series resonant circuit, the impedance of the circuit is

Maximum

Minimum

Zero

Infinite

⇒ In a circuit containing R, L and C, power loss can take place

C only

L only

R only

All of the above

⇒ For a sine wave with peak value I

_{max}the r.m.s. value is

0.5 I

_{max}

0.707 I

_{max}

0.9 I

_{max}

1.414 I

_{max}

⇒ A coil with large distributed capacitance has a

High resonant frequency

Low resonant frequency

Low quality factor

Low resistance

⇒ The form factor of D.C. supply voltage is always

Zero

0.5

Unity

Infinite

⇒ Form factor for a sine wave is

1.414

0.707

1.11

0.637

⇒ Form factor is the ratio of

Average value/r.m.s. value

Average value/peak value

r.m.s. value/average value

r.m.s. value/peak value

⇒ Which of the following circuit component opposes the change in the circuit voltage

Inductance

Capacitance

Conductance

Resistance

⇒ Power factor of electric bulb is

Zero

Lagging

Leading

Unity

⇒ Higher the Q of a series circuit

Broader its resonance curve

Narrower its pass band

Greater its band width

Sharper its resonace

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is

Apparent power

True power

Reactive power

None of the above

⇒ The unit of frequency of an A.C. signal is

Cycle

Cycle-sec

Hertz

Hertz/sec

⇒ For the same peak value of voltage which wave form will have the least r.m.s. value ?

Sine wave

Square wave

Triangular wave

Full wave rectified sine wave

⇒ The ratio of active power to apparent power is known as ____ factor.

Demand

Load

Power

Form

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be____ amperes.

141.4

200

200/π

40/π

⇒ In a parallel R-C circuit, the current always ____the applied voltage.

Lags

Leads

Remains in phase with

None of the above

⇒ If resistance is 20 ω and inductance is 2H in a RL series circuit, then time constant of this circuit will be

0.001 S

0.1 S

10 S

100 S

⇒ The best place to install a capacitor is

Very near to inductive load

Across the terminals of the inductive load

Far away from the inductive load

Any where

⇒ At____ frequencies the parallel R-L circuit behaves as purely resistive.

Low

Very low

High

Very high

⇒ A heater is rated as 230 V, 10 KW, AC. The value 230 V refers t

Average voltage

r.m.s. voltage

Peak voltage

None of these

⇒ The shunt element of prototype high pass filter is

Resistive

Inductive

Capacitive

Combination of L and C

⇒ The shunt element in a band pass filter is

Capacitive

Inductive

Parallel combination of L and C

Series combination of L and C

⇒ The power factor of incandescent bulb is

0.8 lagging

0.8 leading

Unity

Zero