Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Which of the following circuit component opposes the change in the circuit voltage |

A. | Inductance [Wrong Answer] |

B. | Capacitance [Correct Answer] |

C. | Conductance [Wrong Answer] |

D. | Resistance [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :Arvind Said on 2016-10-19 09:03:51Inductance: Opposes the change in ckt current Capacitance: Opposes the change in ckt voltage Conductance: Supports the flow of current Resistance: Opposes the flow of current. ♥Reciprocal of Resistance(R) is conductance(G). (R=1/G) !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees

90

60

45

30

⇒ Selectivities of different resonance circuits are compared in terms of their

Impedances

Reactances

Frequencies

Band widths

⇒ For the same peak value which of the following wave will have the highest r.m.s. value ?

Square wave

Half wave rectified sine wave

Triangular wave

Sine wave

⇒ The dual of a loop is

Twig

Node pair

Mesh

Tree

⇒ The shunt element of prototype high pass filter is

Resistive

Inductive

Capacitive

Combination of L and C

⇒ The best place to install a capacitor is

Very near to inductive load

Across the terminals of the inductive load

Far away from the inductive load

Any where

⇒ The capacitors for power factor correction are rated in terms of

Voltage

VA

kW

kVAR

⇒ Inductance affects the direct current flow

Only at the time of turning off

Only at the time of turning on

At the time of turning on and off

At all the time of operation

⇒ The form factor of D.C. supply voltage is always

Zero

0.5

Unity

Infinite

⇒ The power is measured in terms of decibles in case of

Electronic equipment

Transformers

Current transformers

Auto-transformers

⇒ Which of the following waves has the highest value of peak factor '?

Square wave

Sine wave

Half wave rectifier sine wave

Triangular wave

⇒ The series element of a band stop filter is

Capacitive

Inductive

Parallel combination of L and C

Series combination of L and C

⇒ A parallel resonant circuit can be used

As a high impedance

To reject a small band of frequencies

Both (A) and (B)

To amplify certain frequencies

⇒ The value of operator j2 is equal to

Zero

+1

-1

√-1

⇒ Two sinusoidal quantities are said to be phase quadrature, when their phase difference is

0

30°

45°

90°

⇒ A heater is rated as 230 V, 10 KW, AC. The value 230 V refers t

Average voltage

r.m.s. voltage

Peak voltage

None of these

⇒ At half power points of a resonance curve, the current is____ times the maximum current.

1/2

1/ √2

√2

2

⇒ A network is said to be non-linear if it does not satisfy

Homogeneity condition

Superposition condition

Both (A) and (B)

Associative condition

⇒ In a series resonant circuit, the impedance of the circuit is

Maximum

Minimum

Zero

Infinite

⇒ The peak value of a sine wave is 200 V. Its average value is

127.4V

141.4V

282.8V

200 V

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates

Low efficiency

High power factor

Unity power factor

Maximum Load current

⇒ The r.m.s. value and mean value is the same in the case of

Triangular wave

Sine wave

Square wave

Half wave rectified sine wave

⇒ Which of the following is not a non-linear element ?

Transistor

Heater coil

Diode

Electric arc with unlike electrodes

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be____ amperes.

141.4

200

200/π

40/π

⇒ Skin effect occurs when a conductor carries current at____ frequencies.

Very low

Low

Medium

High

⇒ How much r.m.s. current does a 300 W. 200V bulb take from the 200 V, 50 Hz power line ?

0.5A

1.5 A

2A

3A

⇒ The time constant of a series R-C circuit is given by

R/C

RC

^{2}

RC

R

^{2}C

⇒ Power factor of an inductive circuit is usually improved by connecting capacitor to it in

Parallel

Series

Either (A) or (B)

None

⇒ The power consumed in a circuit element will be least when the phase difference between the current and voltage

180°

90°

60°

0°

⇒ Ohm is the unit of all of the following except

Inductive reactance

Capacitive reactance

Resistance

Capacitance