Question is ⇒ At____ frequencies the parallel R-L circuit behaves as purely resistive., Options are ⇒ (A) Low, (B) Very low, (C) High, (D) Very high, (E) , Leave your comments or Download question paper.

Question is ⇒ At____ frequencies the parallel R-L circuit behaves as purely resistive., Options are ⇒ (A) Low, (B) Very low, (C) High, (D) Very high, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	At____ frequencies the parallel R-L circuit behaves as purely resistive.
A.	Low [Wrong Answer]
B.	Very low [Wrong Answer]
C.	High [Wrong Answer]
D.	Very high [Correct Answer]
View Answer 17 -14 Explanation:- Answer : D Discuss it below : Mehul Vanzara Said on 2020-10-03 21:22:27 Capacitors for power factor correction are rated in !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In A.C. circuit laminated iron is invariably used in order to
Reduce eddy current loss
Increase heat radiation
Make assembly cheap and easier
Reduce circuit permeability

⇒ Skin effect occurs when a conductor carries current at____ frequencies.
Very low
Low
Medium
High

⇒ The voltage of domestic supply is 220 V. This figure represents-
Mean value
r.m.s. value
Peak value
Average value

⇒ The form factor of D.C. supply voltage is always
Zero
0.5
Unity
Infinite

⇒ The r.m.s. value of a sine wave is 100A. Its peak value is
70.7 A
141.4A
150A
282.8 A

⇒ Capacitors for power factor correction are rated in
kW
kVA
kV
kVAR

⇒ Selectivities of different resonance circuits are compared in terms of their
Impedances
Reactances
Frequencies
Band widths

⇒ The time constant of a series R-C circuit is given by
R/C
RC²
RC
R²C

⇒ For the same peak value of voltage which wave form will have the least r.m.s. value ?
Sine wave
Square wave
Triangular wave
Full wave rectified sine wave

⇒ In an A.C. circuit I sin Φ is called
Active component
Wattless component
Any of the above
None of these

⇒ The transient currents are associated with the
Changes in the stored energy in the inductors and capacitors
Impedance of the current
Applied voltage to the circuit
Resistance of the circuit

⇒ For 200 V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
282 V
346 V

⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637

⇒ A heater is rated as 230 V, 10 KW, AC. The value 230 V refers t
Average voltage
r.m.s. voltage
Peak voltage
None of these

⇒ A coil with large distributed capacitance has a
High resonant frequency
Low resonant frequency
Low quality factor
Low resistance

⇒ The product of apparent power and cosine of the phase angle between circuit voltage and current is
True power
Reactive power
Volt-amperes
Instantaneous power

⇒ Form factor is the ratio of
Average value/r.m.s. value
Average value/peak value
r.m.s. value/average value
r.m.s. value/peak value

⇒ The power factor of a D.C. circuit is always
Less than unity
Unity
Greater than Unity
Zero

⇒ In a circuit containing R, L and C, power loss can take place
C only
L only
R only
All of the above

⇒ At____ frequencies the parallel R-L circuit behaves as purely resistive.
Low
Very low
High
Very high

⇒ At half power points of a resonance curve, the current is____ times the maximum current.
1/2
1/ √2
√2
2

⇒ Power factor of the following circuit will be zero
Resistance
Inductance
Capacitance
Both (B) and (C)

⇒ For the same peak value, which of the following wave has the least mean value ?
Half wave rectified sine wave
Triangular wave
Sine wave
Square wave

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates
Low efficiency
High power factor
Unity power factor
Maximum Load current

⇒ The value of operator j2 is equal to
Zero
+1
-1
√-1

⇒ Poor power factor results in all of the following EXCEPT.
Overloading of transformers
Overloading of altemators
Reduction in power losses
Reduction in load handling capacity of electrical system

⇒ The power factor of a series R-L-C circuit at its half-power points is
Unity
Lagging
Leading
Lagging or leading

⇒ For the same peak value which of the following wave will have the highest r.m.s. value ?
Square wave
Half wave rectified sine wave
Triangular wave
Sine wave

⇒ Which of the following statement is incorrect ?
Resistance is a passive element
Voltage source is an active element
Conductance is a passive element
Current source is a passive element

⇒ The reflection co-efficient of the simplest standing wave is
+1
1
Zero
Infinity