Question is ⇒ When a thyristor is conducting, the voltage drop across it is about, Options are ⇒ (A) 1 V, (B) 10 V, (C) 100 V, (D) 0.1 V, (E) , Leave your comments or Download question paper.

Question is ⇒ When a thyristor is conducting, the voltage drop across it is about, Options are ⇒ (A) 1 V, (B) 10 V, (C) 100 V, (D) 0.1 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a thyristor is conducting, the voltage drop across it is about
A.	1 V [Correct Answer]
B.	10 V [Wrong Answer]
C.	100 V [Wrong Answer]
D.	0.1 V [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ Given digits 2, 2, 3, 3, 3, 4, 4, 4, 4 how many distinct 4 digit numbers greater than 3000 can be formed?
50
51
52
54

⇒ In a transmission line terminated with a load equal to the characteristic impedance, the reflection coefficient is
0
1
-1
Infinity

⇒ The ratio of impurity atoms to intrinsic semiconductor atoms in an extrinsic semiconductor is about.
0.0486111111111111
0.736111111111111
1 : 100000
1 : 10⁸

⇒ For a waveguide, which of the following statements is wrong?
It is usually made of brass or aluminium
It is usually rectangular or circular in shape
The dielectric region is usually air
The wall thickness is very small as compared to skin depth

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil
0
101
1010
1111

⇒ In a radar, the return echo arrives after the allocated pulse interval. Then
the receiver may be over loaded
the target will appear closer than its actual position
the return echo may interfere with transmitter operation
none of the above

⇒ In a varactor diode the increase in width of depletion layer results in
decrease in capacitance
increase in capacitance
no change in capacitance
either (a) or (b)

⇒ For a reflection co-efficient of 0.5, the value of SWR is
-1
1
2
3

⇒ The lowest frequency used in satellite communications is __________ GHz.
0.8
3
18
30

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒

Assertion (A): In a Schottky diode the reverse recovery time is almost zero.

Reason (R): A Schottky diode has aluminium silicon junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one of the following is correct?
RAM is a volatile memory but ROM is non-volatile memory
RAM is non-volatile memory but ROM is volatile memory
Both ROM and RAM are volatile but in ROM data is not lost when power is switched off
Both ROM and RAM are non-volatile but in RAM data is lost when power is switched off

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒ A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make
1200 revolutions
1800 revolutions
2100 revolutions
2400 revolutions

⇒ Which of the following algorithms design techniques is used in quick sort algorithm?
Dynamic programming
Backtracking
Divide and conquer
Greedy

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Assertion (A): Both sodium and ferrous are ferromagnetic.

Reason (R): Both sodium and ferrous have body centred cubic structure.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true