Question is ⇒ An induction wattmeter can be used for, Options are ⇒ (A) dc only, (B) 50 Hz ac only, (C) both ac and dc, (D) high frequency ac only, (E) , Leave your comments or Download question paper.

Question is ⇒ An induction wattmeter can be used for, Options are ⇒ (A) dc only, (B) 50 Hz ac only, (C) both ac and dc, (D) high frequency ac only, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An induction wattmeter can be used for
A.	dc only [Wrong Answer]
B.	50 Hz ac only [Correct Answer]
C.	both ac and dc [Wrong Answer]
D.	high frequency ac only [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency is
100 rad/sec
10000 rad/sec
1000 rad/sec
more than 10000 rad/sec

⇒ The output V_R of the ratio detector is related with the output V_F of similar Foster-Seeley discriminator as follows.
V_R = V_F
V_R < V_F
V_R = 2V_F
V_F = 2V_R

⇒ Consider the following statements:

The positiveness of coefficients of characteristic equation is necessary as well as sufficient condition for stability of first and second order systems.
The positiveness of coefficients of characteristic equation ensures negativeness of real roots but is not sufficient condition for stability of third and higher order systems.

Out of above statements:
only 1 is correct
both 1 and 2 are correct
only 2 is correct
both are wrong

⇒ Which has the highest power dissipation per gate?
ECL
TTL
CMOS
PMOS

⇒ An ungrounded antenna near the ground
is horizontally polarized
acts as an antenna array
acts as a single antenna of twice the height
is not likely to need an earth mat

⇒ In a JK flip-flop, J is connected to Q and K is connected to Q outputs. The JK FF converts into a
RS FF
D FF
T FF
Clocked RS FF

⇒

Assertion (A): In an automobile the amount of fuel admitted to the engine is adjusted as per the difference between desired and actual speed.

Reason (R): The control signal is the amount of fuel to be admitted to the engine.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Calculate the directivity of a given linear end fire, uniform array of 20 element, each separated by λ/3
100
10
26.66
30

⇒ The instruction MVI A, 20 in 8085 means
contents of memory location 20 are brought into the accumulator
the value 20 is brought into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ Fidelity of a receiver represents
the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
the variation of the output with the modulation frequency when the output impedance is a resistance
none of the above

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒ An ac wave with superimposed dc is symmetrical about x - axis.
TRUE
FALSE

⇒

Assertion (A): A two byte instruction of 8085 has an operation code in first byte and operand / address in the second byte.

Reason (R): If an instruction is too long it is possible to reduce its length by a number of methods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In 8085 microprocessor, how many I/O ports can be accessed by direct method?
8
256
32 K
64 K

⇒ Two linearly polarized plane waves A and B travelling in free space in the positive x direction meet at a point. Wave A is polarized in the y direction and the wave B is polarized in the z direction. If the two waves are of equal amplitude and are in phase quadrature, the resultant wave will be
circularly polarized
elliptically polarized
linearly polarized
vertically polarized

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the wave impedance for dominant mode.
130 p
1.3 p
120 p
12 p

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ In single tone FM discriminator (S₀/N₀) is
proportional to deviation
proportional to cube of deviation
proportional to square of deviation
none of the above

⇒ In a reflex klystron oscillator, repeller electrode is at
low positive potential
high positive potential
negative potential
zero potential

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒ A polyphase wattmeter basically consists of two wattmeters. The moving system of two wattmeters
are common
are separate
are generally common
are generally separate

⇒ Which of the following flip flops cannot be converted to D flip flop?
JK
SR
Master slave
None of the above

⇒ Consider the following statements regarding negative feedback

It increases system gain
It improves sensitivity
It improves system stability

Which of these are not correct?
all
1, 2
1, 3
1 only

⇒ Impedance level of Impatt diodes is generally lower than that of Gunn diodes
TRUE
FALSE

⇒ Which of the following is the digital system?
PWM
PAM
PPM
PCM

⇒ In a photodiode the current is due to
majority carriers
minority carriers
both majority and minority carriers
either (a) or (b)

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ Which is a digital coding technique?
PCM
DM
DPCM
All

⇒ EPROM can be
UVPROM
EEPROM
both UVPROM and EEPROM
none of the above