Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>C</td><td>1.</td><td>7 eV</td></tr><tr><td>B.</td><td>Si</td><td>2.</td><td>1.15 eV</td></tr><tr><td>C.</td><td>Ge</td><td>3.</td><td>0.75 eV</td></tr><tr><td>D.</td><td>Sn</td><td>4.</td><td>0.1 eV</td></tr><tr><td>E.</td><td>Pb</td><td>5.</td><td>0 eV</td></tr></tbody></table>, Options are ⇒ (A) A-2, B-3, C-4, D-5, E-1, (B) A-1, B-2, C-3, D-4, E-5, (C) A-3, B-1, C-2, D-5, E-4, (D) A-4, B-5, C-1, D-2, E-3, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>C</td><td>1.</td><td>7 eV</td></tr><tr><td>B.</td><td>Si</td><td>2.</td><td>1.15 eV</td></tr><tr><td>C.</td><td>Ge</td><td>3.</td><td>0.75 eV</td></tr><tr><td>D.</td><td>Sn</td><td>4.</td><td>0.1 eV</td></tr><tr><td>E.</td><td>Pb</td><td>5.</td><td>0 eV</td></tr></tbody></table>, Options are ⇒ (A) A-2, B-3, C-4, D-5, E-1, (B) A-1, B-2, C-3, D-4, E-5, (C) A-3, B-1, C-2, D-5, E-4, (D) A-4, B-5, C-1, D-2, E-3, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	C	1.	7 eV
B.	Si	2.	1.15 eV
C.	Ge	3.	0.75 eV
D.	Sn	4.	0.1 eV
E.	Pb	5.	0 eV

A-2, B-3, C-4, D-5, E-1

A-1, B-2, C-3, D-4, E-5

A-3, B-1, C-2, D-5, E-4

A-4, B-5, C-1, D-2, E-3

View Answer 1 -1

Explanation:-
Answer : B
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours

⇒ In two wattmeter method of 3 phase power measurement, when does one wattmeter read negative
when power factor is less than 0.5 lagging
when power factor is greater than 0.5 lagging
when power factor is less than 0.5
when power factor is unity

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ Principle of superposition is applicable to
linear systems only
nonlinear systems only
both linear and non linear system
linear systems and some nonlinear systems

⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite

⇒ Some sources of TV programs are

TV camera
Telecine
VTR
External signal

Which of the above are actually present in a TV studio?
1, 2, 3 and 4
1, 2, 3
1 and 3
1 2 and 4

⇒

Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Let f(A, B) = A ⊕ B; then the simplified form of the function f(f(x ⊕ y, z)w) is
(x ⊕ y ⊕ z)w
x ⊕ y ⊕ z ⊕ w
(x ⊕ y ⊕ z) + w
none of these

⇒ Spontaneous magnetisation is characteristic of ferromagnetic materials.
TRUE
FALSE

⇒ A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to
decrease the firing angle
increase the firing angle
either decrease or increase the firing angle depending on the required speed
decrease the load torque

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ Piezoelectric quartz crystal resonators find application where
signal amplification is required
rectification of the signal is required
signal frequency control is required
modulation of signal is required

⇒ In the output of a DM speech encoder, the consecutive pulses are of opposite polarity during time interval t₁ < t < t₂. This indicates that during this interval
the input to the modulator is essentially constant
the modulator is going through slope overload
the accumulator is in saturation
the speech signal is being sampled at the Nyquist rate

⇒ The V MOS can handle __________ currents than a conventional MOSFET.
much lower
almost same
almost half
much larger

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt

⇒ Which of the following computer memories is fastest?
Cache
Primary
Mass storage
Off line back up

⇒ Which of the following statements is not true in regard to storage time of a transistor?
The transistor is in active region
Both junctions are forward-biased
The collector injects electrons or holes into the base region
It is the time taken by the carriers to leave the base region

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ In position control system the device used for providing rate feedback voltage is
potentiometer
synchro-transmitter
synchro-transformer
tacho generator

⇒ Degaussing in a picture tube means
Adding magnetism in mask and mounting frame
Removing residual magnetism in mask, shield etc...
Increasing resistance of coils to decrease time constant
Decreasing resistance of coils to increase time constant.

⇒ Which of the following factors are responsible to design IC logic gates to operated at a fixed supply voltage of 5 volts?

Low heating of IC logic gates
Compatibility with other logic gates
Satisfactory and safe operation
Standardization from IC manufacturing point of view.

Select the correct answer from the codes given below:
1 only
2 only
2 and 3
3 and 4

⇒ Heat sink results in
slower dissipation of heat to atmosphere
faster dissipation of heat to atmosphere
lower ambient temperature
lower transistor power

⇒ The direction in a Yagi Uda antenna
is longer than the radiating element
is shorter than the radiating element
can be longer or shorter than the radiating element
does not exist

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒ Figure is a 24 V_r stabilized power supply. The zener is 24 V, 600 mW. The minimum zener current is 10 mA. Proper values R and maximum load current
320 Ω, 10 mA
400 Ω, 15 mA
400 Ω, 10 mA
320 Ω, 15 mA

⇒ When signed numbers are used in binary arithmetic, which of the following has unique representation for zero?
Sign-magnitude
1's complement
2's complement
9's complement

⇒ A sine wave of voltage varies from zero to maximum of 200V. How much is the voltage at the instant of 30° of the cycle?
50 V
82.8 V
100 V
173.2 V

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?
2 kΩ
4 kΩ
8 kΩ
32 kΩ

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes