Question is ⇒ One of the following can be used to generate a pulse whenever triggered, Options are ⇒ (A) flip-flop, (B) monostable multivibrator, (C) stable multivibrator, (D) Schmitt trigger, (E) , Leave your comments or Download question paper.

Question is ⇒ One of the following can be used to generate a pulse whenever triggered, Options are ⇒ (A) flip-flop, (B) monostable multivibrator, (C) stable multivibrator, (D) Schmitt trigger, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	One of the following can be used to generate a pulse whenever triggered
A.	flip-flop [Wrong Answer]
B.	monostable multivibrator [Correct Answer]
C.	stable multivibrator [Wrong Answer]
D.	Schmitt trigger [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a pentavalent impurity is added, the semiconductor becomes
p type
n type
intrinsic
neutral

⇒ The advantage of using crystal oscillator is that it
requires low d.c. supply voltage
works at high frequency
gives high output voltage
gives constant frequency of oscillations

⇒ The two outputs of RS flip-flop are
always low
always high
either low or high
always complementary

⇒ Alternating current can induce voltage because it has magnetic field which is
constant
time varying
stronger field than D.C.
closed loop nature.

⇒

Match the following:

	List I		List II
A.	Television	1.	Either AM or FM used
B.	Radio	2.	Both AM and FM are used
C.	Radar	3.	PCM is used
D.	Data Communication	4.	Digital system

A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4

⇒ The factor n in the equation for calculating current for a silicon diode is
1
2
2.5
2 for low levels of current and 1 for high levels of current

⇒ The unit of loudness is
phon
sone
decibel
mel

⇒ A fully controlled bridge converter can operate in quadrants
1
1 and 2
1 and 3
1 and 4

⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be
18 kV
1.001 kV
6 kV
36 kV

⇒ The maximum efficiency of class A amplifier is
1
0.818
0.5
0.4

⇒ The series element for a prototype high pass filter is
resistive
inductive
capacitive
combination of L and C

⇒ A step voltage E is applied to an R-L series circuit. At t = 0, the current in the circuit is
E/R
E/L
infinity
zero

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ Impedance level of Impatt diodes is generally lower than that of Gunn diodes
TRUE
FALSE

⇒ In which of these does thermionic emission occur?
LED
LCD
VF display
None

⇒ RF amplifiers are used in radio receivers for
better sensitivity
improved signal-to-noise ratio
better coupling of receiver to the antenna
all of the above

⇒

Assertion (A): The response of a network to unit impulse can be obtained directly from the network function.

Reason (R): The response of a network for any input can be obtained from impulse response.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ A 12 bit ADC is used to convert analog voltage of 0 to 10 V into digital. The resolution is
2.44 mV
24.4 mV
1.2 V
none of the above

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ In the circuit of figure the voltage across capacitor when switch is closed at t = &infin
0 V
20 V
very large
7.5 V

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
1
2
3
4

⇒ The effective channel length of a MOSFET in saturation decreases with increase in
gate voltage
drain voltage
source voltage
body voltage

⇒ In 8085 microprocessor, what is the memory word addressing capability?
32 K
64 K
256 K
512 K

⇒ For edge triggering in flip flops, manufacturers use
RC circuit
direct coupled design
either RC circuit or direct coupled design
none of the above

⇒

Assertion (A): When the forward gain of a system is increased, the transient response becomes oscillatory.

Reason (R): Increasing the forward gain reduces steady state error.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as
A ⊕ B ⊕ D
A ⊕ B ⊕ E
A ⊕ E
A ⊕ E

⇒ In a capacitor filter, the time constant R_LC should be small.
TRUE
FALSE

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323