Question is ⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be, Options are ⇒ (A) 0.6 Ω, (B) 0.06 Ω, (C) 0.1 Ω, (D) 0.004 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be, Options are ⇒ (A) 0.6 Ω, (B) 0.06 Ω, (C) 0.1 Ω, (D) 0.004 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
A.	0.6 Ω [Wrong Answer]
B.	0.06 Ω [Wrong Answer]
C.	0.1 Ω [Wrong Answer]
D.	0.004 Ω [Correct Answer]
View Answer 3 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?
V_BE versus i_B for constant values of V_CE
V_CE versus i_C for constant values of I_B
V_CE versus i_C for constant values of I_E
None of the above

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ In a synchronous counter all flip flops are clocked together.
TRUE
FALSE

⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
0.6 Ω
0.06 Ω
0.1 Ω
0.004 Ω

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none

⇒ Which of the following has highest resistivity?
Mica
Paraffin wax
Air
Mineral oil

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒

Assertion (A): In C arithmetic operations are pemiissible on ints, floats and chars.

Reason (R): In C every arithmetic operator must be written explicitly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): When performance specifications are given in term of transient response characteristics, root locus method is a suitable method.

Reason (R): When performance specifications in terms of state variables are given, modern control methods can be used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ High frequency oscillations can be caused by
electric coupling
magnetic coupling
ground loop
all of the above

⇒ In a clocked latch, clock drives
R NAND gate
S NAND gate
both R and S NAND gates
either R or S NAND gates

⇒ A voltage doubler circuit is fed by a voltage V_m sin ωt. The output voltage will be nearly 2 V_m only if
load resistance is small
load resistance is large
load resistance is neither small nor large
either (a) or (c)

⇒ Acoustic strain gauges
have good linearity of measurement
do not have long term stability
have a large range of measurement
have an accuracy range of 0.1-1% depending on environment

⇒ In a single phase full converter fed by a source having inductance, the number of thyristors conducting during overlap is
1
2
3
4

⇒ If the frequency of a wave 20 Hz, the time period is
20 secs
2 secs
0.2 secs
0.05 secs

⇒ In the given fi
42737
42739
2
1

⇒ A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m² and Young's modulus is 200 giga newton/ m², the percentage change in gauge resistance due to stress is
0.1
0.2
0.4
0.5

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ The initial state of MOD-16 down counter is 0110. What state will it be after 37 clock pulses?
Indeterminate
110
101
1

⇒ The radiation resistance of a resonant long wire antenna of half wavelength (λ/2) is given
73 Ω
120 p
377 Ω
7.3 Ω

⇒ Which of the following modes cannot exist in rectangular resonant cavity?
TE₁₁₀
TE₀₁₁
TM₁₁₀
TM₁₁₁

⇒ In figure, the steady state current through 1H inductanc
Zero
0.125
0.208333333333333
0.25

⇒ The output of basic DTL configuration is
low when one of the input is high
low when all inputs are high
high when all inputs are high
high when all inputs are low

⇒ In a CD player the laser uses
silicon semiconductor
silicon/germanium semiconductor
aluminium gallium arsenide semiconductor
none of the above

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒

Assertion (A): Doping level in extrinsic semiconductors is very small.

Reason (R): Additional of impurity in the ratio of 1 part in 10⁸ parts increases the number of charge carriers by about 20.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure, thyristor Th is in off state. When thyristor is turned on, the peak thyristor current can
0.208333333333333
0.416666666666667
15 A
20 A

⇒ In a JFET, the drain current is maximum when
V_GS = V_DS
V_GS = pinch off voltage
V_GS = 0
V_GS is negative