Question is ⇒ In a three phase series inverter, the firing frequency is, Options are ⇒ (A) three times output frequency, (B) six times output frequency, (C) twice the output frequency, (D) equal to output frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ In a three phase series inverter, the firing frequency is, Options are ⇒ (A) three times output frequency, (B) six times output frequency, (C) twice the output frequency, (D) equal to output frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a three phase series inverter, the firing frequency is
A.	three times output frequency [Wrong Answer]
B.	six times output frequency [Correct Answer]
C.	twice the output frequency [Wrong Answer]
D.	equal to output frequency [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If each branch of a Delta circuit has impedance 3 Z then each branch of the equivalent Y circuit has impedance.
Z/3
3 Z
3/3 Z
Z/3

⇒ Secondary emission occurs in
diode
triode
tetrode
pentode

⇒ An oscillator at 4.2 MHz is followed by two frequency doublers and two triplers. The output frequency will be
84 MHz
112.4 MHz
151.2 MHz
303.4 MHz

⇒ Which connection is rarely used?
CE
CB
CC
Both (a) and (b)

⇒ In figure, capacitor is uncharged. The switch is closed at t = 0 at t = 0⁺ di/dt100 A/s
-100 A/s
1000 A/s
-1000 A/s

⇒ ∈₀ has no other physical meaning than that of a fundamental conversion factor.
TRUE
FALSE

⇒ The advantage of pulse modulation is
the transmitted power can be concentrated into short bursts
the time intervals between pulses can be filled with sample values from other message
pulse wave may obtain appreciable D.C. and low frequency content
all of the above

⇒ Read the following statements: Dual slope ADC provides
higher speed as compared to other ADC
very good accuracy
good rejection of power supply
better resolutions compared to other ADC for the same number of bits
Which of the above are correct?
1 and 2
2 and 3
1, 2, 3
1, 2, 3, 4

⇒
Assertion (A): In p-n-p transistor collector current is termed negative.
Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8

⇒
Assertion (A): SUS is a PUT and avalanche diode connected between gate and cathode
Reason (R): SBS has two SUS inbuilt together and connected in anti-parallel

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be
about 1350 rpm
about 720 rpm
about 360 rpm
either (b) or (c)

⇒ In 8085, usually the vector location and the next two memory location contain a JMP instruction. This allows the programs to branch to
a longer subroutine
a shorter subroutine
a subroutine free path
none of the above

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ The colour code on a carbon resistor is green-blue-yellow. The tolerance is
± 5%
± 10%
± 20%
± 30%

⇒ A thermocouple instrument can be used over a very wide frequency range.
TRUE
FALSE

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ The word size accessible at a time from the memory subsystem depends on
width of data bus
width of address bus
width of control bus
both (b) and (c)

⇒ The number of noise sources in a BJT are
3
2
1
4

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒ An ac voltage 20 sin 1000t feeds an R-C series circuit. R = 8 Ω and active power is 4 W. The power factor is
1
0.8
0.6
0.4

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ In an n channel JFET
I_D, I_S and I_G are considered positive when flowing into the transistor
I_D and I_S are considered positive when flowing into transistor and I_G is considered positive when flowing out of it
I_D, I_S, I_G are considered positive when flowing out of transistor
I_S and I_G are considered positive when flowing into transistor and I_D is considered positive when flowing out of it

⇒ Dual slope ADC uses an op amp comparator.
TRUE
FALSE

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ The intermediate frequencies in VCR are
video 38.9 MHz and audio 33.4 MHz
38.9 MHz for both video and audio
33.4 MHz for both video and audio
33.4 MHz for video and 38.9 MHz for audio

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒
Assertion (A): The number ∈ such that the probability that an error is between -∈ and + ∈ is 1 is called probable error of single obserevation.
Reason (R): The standard deviation is the arms value of the deviation from the arithmetic mean.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In figure, R = 20KΩ and C = 75 pF. The converter clock frequency wil
606 Hz
1212 Hz
555 KHz
606 KHz

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math