Question is ⇒ When two 4 bit parallel adders are cascaded we get, Options are ⇒ (A) 4 bit parallel adder, (B) 8 bit parallel adder, (C) 16 bit parallel adder, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ When two 4 bit parallel adders are cascaded we get, Options are ⇒ (A) 4 bit parallel adder, (B) 8 bit parallel adder, (C) 16 bit parallel adder, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When two 4 bit parallel adders are cascaded we get
A.	4 bit parallel adder [Wrong Answer]
B.	8 bit parallel adder [Correct Answer]
C.	16 bit parallel adder [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Two equal and opposite travelling waves result in a standing wave.

Reason (R): The ratio of maximum to minimum value of a standing wave is called SWR.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if
A = 1, B = 1, S = 1
A = 1, B = 1, S = 0
A = 1, B = 0, S = 1
A = 1, B = 0, S = 0

⇒ Which of the following is a passive component?
Semiconductor devices
Vacuum tube devices
Capacitors
All of the above

⇒ An n channel JFET has I_DS whose value is
maximum for V_GS = 0 and minimum for V_GS negative and large
minimum for V_GS = 0 and maximum for V_GS negative and large
maximum for V_GS = 0 and minimum for V_GS positive and large
minimum for V_GS = 0 and maximum for V_GS positive and large

⇒ Two wattmeter method of 3-phase power measurement can be used to find
total active power
total active power and power factor
total active power and reactive power
total active power, power factor, apparent power, and reactive power

⇒ If an inductance L is connected in one arm of bridge and resistance R₁, R₂, R₃ in other three arms
the bridge cannot be balanced
the bridge can be balanced
the bridge is balanced for some specified value of frequency
the bridge is balanced for some specific values of R₁, R₂, R₃

⇒ For the collector-feedback amplifier shown below the voltage gain A_v will be _________
-113.07
-103.07
-107.07
-93

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒ A moving iron instrument gives correct reading when used at
low frequencies
high frequencies
only one frequency
all frequencies upto a certain value

⇒ Which of the following is 'synchronous'?
Half adder
Full adder
R-S flip-flop
Clocked R-S flip-flop

⇒ Which is correct for a vacuum triode?
μ = r_pg_m
r_p = μg_m
g_m = μr_p
r_pg_m

⇒ For transmission line load matching over a range of frequencies, it is best to use a
double stub
balun
single stub of adjustable position
broadband directional coupler

⇒ A microprocessor uses 3 MHz oscillator. The duration of one T state is
1 μs
0.666 μs
0.333 μs
3 μs

⇒ Two identical NMOS transistors M₁ and M₂ are connected as shown below. V_bias is chosen so that both transistors are in saturation. The equivalent g_m of the pair is defined t
the sum of individual g_m's of the transistors
the product of individual g_m's of the transistors
nearly equal to the g_m of M₁
nearly equal to g_m / g₀ of M₂

⇒ If the changes in zener current in a voltage regulator circuit are too large, it can be corrected by using a
emitter follower
CE amplifier
capacitor
either (a) or (b)

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ UHF and microwaves in the frequency range 300 MHz to 30 GHz can be best transmitted using __________ propagation
sky wave
ground wave
duct
none of the above

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒ In figure v₁ = 8 V and v₂ = 4 V. Which diode will cond
D₂ only
D₁ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ The number of lobes on each side of a 31 resonant antenna will be
2
3
4
6

⇒ Which of the following is not an integer constant?
2.3
156231
10
-256

⇒ Ground wave can be used for communication upto
5 kHz
12 kHz
16 kHz
25 kHz

⇒ A negative feedback can be of
2 types
3 types
4 types
only 1 type

⇒ A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is
1.5 V
2.0 V
3.0 V
4.5 V

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ The absorption of EM wave by the atmosphere depends on
polarization of waves
frequency in use
dist. from T_y
height of antenna

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then carrier frequency is
0.159 MHz
1.59 MHz
15.9 MHz
159 MHz

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7