Question is ⇒ In figure VCE (sat) = 0.1 V. Then IC (sa, Options are ⇒ (A) 10 mA, (B) 20 mA, (C) 30 mA, (D) 40 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure VCE (sat) = 0.1 V. Then IC (sa, Options are ⇒ (A) 10 mA, (B) 20 mA, (C) 30 mA, (D) 40 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure V_CE (sat) = 0.1 V. Then I_C (sa
A.	10 mA [Wrong Answer]
B.	20 mA [Correct Answer]
C.	30 mA [Wrong Answer]
D.	40 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Who developed the concept of time varying electric field producing a magnetic field?
Gauss
Faraday
Hertz
Maxwell

⇒ In EPROM integrated dose is defined as
UV light intensity x exposure time in seconds
UV light intensity / exposure time in seconds
exposure time in seconds / UV light intensity
none of the above

⇒ The units of thermal capacitance are
k cal/°C
°C/k cal
°C sec/k cal
none of the above

⇒ An excitation is applied to a system at t = T and the response in zero for -∞ < t < T. This system is
non casual
stable
casual
unstable

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒

Assertion (A): In 8085, P flag is for parity checking.

Reason (R): If the result of ALU has even parity, P flag is set and if the result has odd parity, P flag is reset.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A class D chopper
can operate in first quadrant only
can operate in second quadrant only
can operate in either first or fourth quadrant
can operate in all the quadrants

⇒ In figure if C is replaced by short circuit then R_B wil
425 K
412 K
474 K
400 K

⇒ In a minimum function
the degree of numerator and denominator are equal
the degree of numerator and denominator are unequal
the degree of numerator is one more than degree of denominator
the degree of numerator is one less than degree of denominator

⇒ The given figure shows a K-map for a Boolean function. The number of essential prime implicant
4
5
6
8

⇒ The number of spectral component when two sine wave of same frequency multiplied is
2
3
∞
4

⇒ The disadvantage of transformer coupling in amplifier is
cost of transformer at audio frequencies
size of transformer at audio frequencies
size of transformer at radio frequencies
cost and size of transformer at audio frequencies

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ In microwave communication links, when fading due to rain attenuation occurs then technique adopted for solving the problem would include
antenna replacement and feed correction
amplitude timing and phase correction
polarization shifting and code diversity
path diversity and frequency diversity

⇒ An exponential amplifier has diode in feedback path.
TRUE
FALSE

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be
1.116
1.386
2.116
2.386

⇒ Parabolic and lens antenna used at
microwave frequency
medium frequency
low frequency
high frequency

⇒ Consider the following about 'return' statement in C

On executing the return statement, it immediately transfers the control back to the calling program.
There is no restriction on the number of 'return' statements present in a function.
The 'return' statement must be present at the end of called function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒

Assertion (A): Power drain of CMOS increases with operating frequency

Reason (R): All unused CMOS inputs should be tied either to a fixed voltage level (0 or V_DD) or to another input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The n state variables can be considered as n components of a state vector.
TRUE
FALSE

⇒ Figure shows a dc circuit fed by a current source. With respect to terminals AB, Thevenin's voltage and Thevenin's resistance
V_TH = 5 V, R_TH = 0.75 Ω
V_TH = 2.5 V, R_TH = 0.75 Ω
V_TH = 2.5 V, R_TH = 1 Ω
V_TH = 5 V, R_TH = 1 Ω

⇒ Two coils are connected in parallel. Their fluxes are adding. If the connections of one of the coils are reversed, the total inductance of the arrangement
will decrease
may increase or decrease
will remain the same
will increase

⇒ The number of roots of s³ + 2s² + 7s + 3 = 0 in the left half of the s-plane is :
zero
one
two
three

⇒ Which of the following is Doppler effect not used?
CW radar
FM radar
MTI system
Moving target plotting on PPI

⇒

Assertion (A): Static RAMS are used where speed of operation is of primary concern.

Reason (R): Dynamic RAM has lower cost per bit than static RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ If E is energy level of electron and E_F is Fermi level, then
all quantum states with E less than E_F will be occupied at T = 0
all quantum states with E less than E_F will be empty at T = 0
some quantum states with E less than E_F will be occupied at T = 0
none of the above

⇒ For the differential equation (D³ - D² + D -1) [y(t)] = 0 the root of auxiliary equation
-j, j, 1
-j, j, 2
1, 2, j
1, 2, -j