Question is ⇒ Two resistances are : R1 = 36 Ω ± 1.89 Ω and R2 = 75 Ω ± 3.75 Ω. The sum R1 + R2 along with limiting error is, Options are ⇒ (A) 111 Ω ± 1.8 Ω, (B) 111 Ω ± 3.75 Ω, (C) 111 Ω ± 5.55 Ω, (D) 111 Ω ± 1.95 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ Two resistances are : R1 = 36 Ω ± 1.89 Ω and R2 = 75 Ω ± 3.75 Ω. The sum R1 + R2 along with limiting error is, Options are ⇒ (A) 111 Ω ± 1.8 Ω, (B) 111 Ω ± 3.75 Ω, (C) 111 Ω ± 5.55 Ω, (D) 111 Ω ± 1.95 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two resistances are : R₁ = 36 Ω ± 1.89 Ω and R₂ = 75 Ω ± 3.75 Ω. The sum R₁ + R₂ along with limiting error is
A.	111 Ω ± 1.8 Ω [Wrong Answer]
B.	111 Ω ± 3.75 Ω [Wrong Answer]
C.	111 Ω ± 5.55 Ω [Correct Answer]
D.	111 Ω ± 1.95 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): As the length of the resonant antenna is increased, the number of lobes increases and the direction of the major lobes is closer and closer to the direction of the diode.

Reason (R): As the length increases, the current distribution along the wire becomes more and more uniform.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Full duplex operation
requires modems at both ends of circuit
requires two pairs of cables
can transfer data in both directions simultaneously
all of the above

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ In ac bridge measurements, 'Wagner ground' means
a special RC connection to eliminate stray magnetic effects
a special RC connection to eliminate stray capacitance effects
an unwanted and unintended ground connection
a large metal plate buried in ground connected to one corner of bridge

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒ What does the B register contain after the first MOV B, A has been executed?
40 H
60 H
80 H
80 D

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
6 dB and 180°
3 dB and 180°
6 dB and 90°
3 dB and 90°

⇒ A decade counter
counts for ten days
counts ten times faster than a binary counters
counts to 9 and reset on the next pulse
reverts on the pulse after the tenth

⇒ (62)₁₀ in binary system is
110000
111100
111110
111111

⇒

Assertion (A): A multiplexer can be used for data routing.

Reason (R): A multiplexer has one input and many outputs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ To make antenna more directional, either its size must be increased or
the number of its feed horns must be increased
the frequency of its transmission must be increased
its effective isotropic radiated power (EIRP) must be increased
its footprint must be increased

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ For a series circuit of R and variable X_L the admittance locus is
a semicircle in first quadrant
a semicircle in fourth quadrant
a straight line in first quadrant
a straight line in fourth quadrant

⇒ Which of the following instruments is used almost exclusively to measure radio frequency currents?
Moving coil
Rectifier
Moving iron
Thermocouple

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒ In the circuit of figure v₁ = 8 V and v₂ = 0. Which diode will conduct (Assume ideal diod
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒ In Pulse Code Modulation system
large bandwidth is required
quantising noise can be overcome by companding
quantising noise can be reduced by decreasing the number of standard levels
suffers from the disadvantage of its incompatibly with TDM

⇒ Which of the following draws minimum power from source?
PMMC
Electronic voltmeter
Electrostatic voltmeter
Moving iron voltmeter

⇒ Which of the following materials in not an insulator?
Diamond
Graphite
Bakelite
Lucite

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ Electrons can be emitted from a metal surface due to high electric field.
TRUE
FALSE

⇒ Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
electrostriction
acousto-optic interaction
acousto-electric interaction
stimulated Brillouin scattering

⇒ Materials in order of decreasing electrical conductivity are
aluminium, silver, gold, copper
gold, silver, copper, aluminium
copper, silver, gold, aluminium
silver, copper, gold, aluminium

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine

⇒ The bidirectional pattern of a broadside array can be converted into unidirectional by
maintaining the distance of λ/4 between the elements
maintaining the distance of λ/2 between the elements
installing an identical array behind the main array at distance λ/4 and exciting it by current leading in phase by 90°
installing an identical array behind the main array at distance λ/2 and exciting it by current leading in phase by 120°

⇒ The 8086 arithmetic instruction work on

signed and unsigned numbers
ASCII data
unpacked BCD data

Select the correct answer using the codes given below :
1 and 2
1 and 3
2 and 3
1, 2 and 3