Question is ⇒ In a CRO the Y plates are oriented, Options are ⇒ (A) horizontally, (B) vertically, (C) at an angle of 20° of horizontal, (D) at an angle of 70° of horizontal, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CRO the Y plates are oriented, Options are ⇒ (A) horizontally, (B) vertically, (C) at an angle of 20° of horizontal, (D) at an angle of 70° of horizontal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CRO the Y plates are oriented
A.	horizontally [Correct Answer]
B.	vertically [Wrong Answer]
C.	at an angle of 20° of horizontal [Wrong Answer]
D.	at an angle of 70° of horizontal [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Hexadecimal number E is equal to binary number
1110
1101
1001
1111

⇒ An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if
A = 1, B = 1, S = 1
A = 1, B = 1, S = 0
A = 1, B = 0, S = 1
A = 1, B = 0, S = 0

⇒ In figure V_i may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω

⇒ Lowest resistivity of the following is
constantan
german silver
manganin
nichrome

⇒ The early effect in a BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ Which of the following methods can be used to measure power in a single phase circuit without using wattmeter?

One voltmeter, one ammeter
Two voltmeters, two ammeter
Three voltmeters
Three ammeters

1 and 2 only
2 and 4 only
1 and 3 only
3 and 4 only

⇒ A parametric amplifier uses
non linear resistance
non linear reactance
either (a) or (b)
neither (a) nor (b)

⇒ Resistivity of carbon is around
10 to 70 m-ohm-cm
80 to 130 m-ohm-cm
800 to 1300 m-ohm-cm
8000 to 13000 m-ohm-cm

⇒

Assertion (A): PIN diode can be used as attenuator and limiter.

Reason (R): PIN diode has a thin intrinsic layer.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Assuming earth to be a sphere of radius 6400 km and height of a geosynchronous satellite above Earth as 36000 km, the velocity of a geosynchronous satellite is __________ km/hr.
28000
15000
36000
11100

⇒ Two voltages are 50 ∠0 V and 75 ∠ - 60° V. The sum of these voltages is
109 ∠ - 60° V
109 ∠ - 25° V
109 ∠ - 36.6° V
100 ∠ - 50.1° V

⇒ Consider the following statements as regards communication receiver

Variable sensitivity is used to eliminate selective fading
A product demodulator can be used to receive Morse code
The noise limiter cuts off receiver output during a noise pulse
Double conversion is used to improve image rejection

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ A transmission line has primary constants R, L, G and C and secondary constant z₀ and γ = (a + Jβ). If the line is loss less, then
R = 0, G ≠ 0, and a = 0
R = 0, G = a, 0 and β = |r|
G = 0, a = β
R = 0, G = 0, a = 0, β = |r|

⇒ Two identical silicon diodes D₁ and D₂ are connected back to back shown in figure. The reverse saturation current I_s of each diode is 10^-8 amps and the breakdown voltage V_Br is 50 v. Evaluate the voltages V_D1 and V_D2 dropped across the diodes D₁ and D₂ assuming KT/q to be 25
4.983 V, 0.017 V
- 4.98 V, - 0.017 V
0.17 V, 4.983 V
- 0.017 V, - 4.98 V

⇒

Assertion (A): The gain of an FET amplifier can be changed by changing g_m

Reason (R): Most receivers use automatic gain control to counteract changes in volume caused by fading

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following statements:

Internal sorting is used if the number of items to be sorted is very large.
External sorting is used if the number of items to be sorted is vary large.
External sorting needs auxiliary storage.
Internal sorting needs auxiliary storage.

Which of the above statements are correct?
1 and 2
2 and 3
3 and 4
2 and 4

⇒ Which of the following is used in lightning arresters?
Thermistor
Photoconductor
Transistor
Varistor

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE₁₀ mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be
31.11 mW
31.11 W
31.11 kW
31.11 MW

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ A pulse function having magnitude E and duration from t = 0 to t = a can be represented as
sum of two pulse functions
difference of two pulse functions
difference of two step functions each of magnitude E and one originating at t = 0 and the other at t = a
none of the above

⇒ The number of digits in hexadecimal system
15
16
10
8

⇒

Match the following:

	List I		List II
A.	Output of signal generator	1.	Modulated
B.	Error signal from a synchro	2.	Digital
C.	Output of a JK flip flop	3.	Analog
D.	Signal received by radar	4.	Stoichastic

A-1, B-3, C-2, D-4
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2
A-1, B-3, C-4, D-2

⇒ If μ_n is mobility of free electron and μ_p is mobility of holes then for silicon at 300 K
μ_n = μ_p
μ_n > μ_p
μ_n < μ_p
μ_n may be more or less than μ_p

⇒ Automatic sensitivity control by target voltage control is easily possible in
Vidicon
Plumbicon
New vicon
both (b) and (c)

⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
the polarity of voltage across R is same during discharge and during charge
the polarity of voltage across R during discharging is opposite to that during charging
the polarity of voltage across R depends on time constant RC
none of the above

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
0.4456°
1.4456°
2.4456°
3.4456°

⇒ The numerical value of directive gain may lie between
1 and + 1
0 and 1
0 and ∞
1 and ∞

⇒ In 8156, the lower times byte is addressed with 24 H, and the upper times byte with
20 H
23 H
24 H
25 H