Question is ⇒ <code>ALU 1C 74181</code> can accept two words each having, Options are ⇒ (A) 2 bits, (B) 4 bits, (C) 8 bits, (D) 16 bits, (E) , Leave your comments or Download question paper.

Question is ⇒ <code>ALU 1C 74181</code> can accept two words each having, Options are ⇒ (A) 2 bits, (B) 4 bits, (C) 8 bits, (D) 16 bits, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	`ALU 1C 74181` can accept two words each having
A.	2 bits [Wrong Answer]
B.	4 bits [Correct Answer]
C.	8 bits [Wrong Answer]
D.	16 bits [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, the function of resistor
to reduce ripples in the output
to improve voltage regulation
to limit the surge current
either (a) or (c)

⇒ The accumulator drives the ALU.
TRUE
FALSE

⇒ A trigonometric series has
single sided spectra
zero
sync function
undefined

⇒ A receiver having poor IF selectivity will also have poor
sensitivity
double spotting
blocking
all of the above

⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
RST 5.5
RST 7.5
TRAP
INTR

⇒ From the noise point of view, bandwidth should
be large
not be too large
should be as large as possible
should be infinite

⇒

Assertion (A): In class A amplifier the distortion is minimum

Reason (R): In class A amplifier collector current exists for 360° of input cycle

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I		List II
A.	CTFS	1.	Periodic
B.	DTFS	2.	Non-periodic
C.	CTFT
D.	DTFT

A-2, B-1, C-2, D-2
A-2, B-1, C-2, D-1
A-1, B-2, C-2, D-2
A-1, B-2, C-2, D-1

⇒ A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be
9.76 V
1 μV
23.56 μV
6.94 μV

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒ δ(t) is a
energy signal
power signal
neither energy nor power
none

⇒ The product of which of the following gives the figure of merit of a logic family?
Gain and bandwidth
Propagation delay time and power dissipation
Fan-out and propagation delay time
Noise margin and power dissipation

⇒ If V_A = - 10 V and V_B = - 15 V, VAB = 5 V.
TRUE
FALSE

⇒ In a thyristor, the forward breakover voltage
is constant
may be constant or may depend on gate current
decreases as gate current is increased
increases as gate current is increased

⇒ Which one of the following is not a characteristic of a ferroelectric material?
High dielectric constant
No hysteresis
Ferroelectric characteristic only above the curie point
Electric dipole moment

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.
more than 100
100
less than 100
50

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒ When two conductors carry currents in the same direction the force is repulsive.
TRUE
FALSE

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ The symbol in figure is
DIAC
P-N junction diode
Schottky diode
None of the above

⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola

⇒ Consider the following statements :

Tellegen's theorem is applicable to any lumped networks.
The reciprocity theorem is applicable to linear bilateral networks.
Thevenin's theorem is applicable to two- terminal linear active networks.
Norton's theorem is applicable to two-terminal linear active networks.

Which of these statement are correct?
1, 2, and 3
1, 2 and 4
1, 2, 3 and 4
3 and 4

⇒ Two 16 : 1 and one 2 : 1 multiplexers can be connected to form a
16 : 1 multiplexer
32 : 1 multiplexer
64 : 1 multiplexer
8 : 1 multiplexer

⇒

Assertion (A): A DIAC has four layers but only two terminals.

Reason (R): A DIAC can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A thermistor is used for
over voltage protection
temperature alarm circuit
automatic light control
none of the above

⇒ In a network containing resistances, reactances the root of the characteristic equation give for the circuit
the forced response
the total response
the natural response
the damped response

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ In figure V_CEQ for each transisto
V_CC
0.5 V_CC
0.75 V_CC
0.25 V_CC

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa