Question is ⇒ An inductance having XL = 5 Ω and a capacitance having XC = 5 Ω are connected in parallel across 100 V, 50 Hz supply. The current drawn from source is, Options are ⇒ (A) zero, (B) 20 A, (C) 40 A, (D) 28.28 A, (E) , Leave your comments or Download question paper.

Question is ⇒ An inductance having XL = 5 Ω and a capacitance having XC = 5 Ω are connected in parallel across 100 V, 50 Hz supply. The current drawn from source is, Options are ⇒ (A) zero, (B) 20 A, (C) 40 A, (D) 28.28 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An inductance having X_L = 5 Ω and a capacitance having X_C = 5 Ω are connected in parallel across 100 V, 50 Hz supply. The current drawn from source is
A.	zero [Correct Answer]
B.	20 A [Wrong Answer]
C.	40 A [Wrong Answer]
D.	28.28 A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit, shown in figure, V₀ = V_i. The values of 1, m, n are: (x represents don't care conditi
0, 1, 1
∞, x, x
x, ∞, x
0, x, ∞

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ Which one of the following is not a negative resistance device?
Gunn diode
Tunnel diode
Impatt diode
Varactor diode

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}

⇒ Consider the following statements : A clamper circuit

adds or subtracts a dc voltage to a waveform
does not change the waveform
amplifiers the waveform

Which are correct?
1, 2
1, 3
1, 2, 3
2, 3

⇒ The angle subtended by earth at geostationary communication satellite is
17.34°
51.4°
120°
60°

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ For overdamped systems a quadratic factor in transfer function can be replaced by two first order factors with real poles
TRUE
FALSE

⇒ Henry is equivalent to
Volts/Ampere
Weber/Volt
Weber/Ampere
Weber/Ampere²

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ In a TWT the amplitude of resultant wave travelling down the helix remains constant
TRUE
FALSE

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒ In a highly capacitive circuit the
apparent power is equal to the actual power
reactive power is more than the apparent power
reactive power is more than the actual power
actual power is more than its reactive power

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured
at lowest gain crossover frequency
at highest gain crossover frequency
at the gain crossover frequencies
none of the above

⇒ The number of flags available in 6800 are
6
5
7
4

⇒ Z flag is reset if an ALU operation results in 0.
TRUE
FALSE

⇒ The counter shown in figure is built using 4 negative edge triggered toggle FFs. The FFs can be set synchronously when R = 0. The combinational logic required to realize a modulo 13 counte
F= Q₄ Q₃ Q₂ Q₁
F= Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ Q₃ Q₂ Q₁

⇒ If memory chip size is 256 x 1 bits, the number of chips required to make 1 k byte memory is
8
12
24
32

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒ The quiescent collector current I_C, and collector to emitter voltage V_CE in a CE connection are the values when
ac signal is zero
ac signal is low
ac signal is negative
either (a) or (b)

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ If Y(s) = 1 + s, the network has
1 Ω resistor and 1 F capacitor in series
1 Ω resistor and 1 F capacitor in parallel
1 Ω resistor and 1 H inductor in series
1 Ω resistor and 1 H inductor in parallel

⇒ Consider the following rules for constructing variable names in C

It can have alphabets, digits or underscores but no other special character.
The maximum number of characters is 8.
The first character may be an alphabet or digit but not underscore.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The resonance frequency is
ω_r = a
ω_r = b
ω_r = k
ω_r = ba

⇒ The purpose of earthing electric appliances is
to provide safety against shock
to ensure that appliance works satisfactorily
to ensure that appliance gets full voltage
all of the above

⇒ 268₁₀ = __________ .
10A₁₆
10B₁₆
10C₁₆
10D₁₆

⇒ For formation of state equations, resistance of the circuit
should be in tree
should be in cotree
may be in tree or cotree
none of the above

⇒ In the op-amp circuit of figure, V_{010 V
-10 V
5 V
-5 V}