Question is ⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is, Options are ⇒ (A) a resistor, (B) a capacitor, (C) an inductor, (D) a diode, (E) , Leave your comments or Download question paper.

Question is ⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is, Options are ⇒ (A) a resistor, (B) a capacitor, (C) an inductor, (D) a diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The element in the feedback circuit of a logarithmic amplifier using op-amp is
A.	a resistor [Wrong Answer]
B.	a capacitor [Wrong Answer]
C.	an inductor [Wrong Answer]
D.	a diode [Correct Answer]
View Answer 2 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In VCR the luminance signal is recorded by
frequency modulation
phase modulation
amplitude modulation
direct recording

⇒ Input and output impedance with feedback for voltage series feedback having A = -200, R₁ = 10 kΩ, R₀ = 50 kΩ and feedback factor β = -0.2 will be
410 kΩ, 2050 kΩ
410 kΩ, 1.219 kΩ
≈ 0.243 kΩ, 2050 kΩ
≈ 0.24 kΩ, 1.219 kΩ

⇒

Match the following:

	List I		List II
A.	Flash converter ADC	1.	requires conversion time of a few μs
B.	Dual slope ADC	2.	requires DAC
C.	Successive approximation ADC	3.	minimizes the effect of power supply interference
		4.	requires complex hardware
		5.	is a tracking ADC

A-2, B-3, C-4
A-4, B-3, C-2
A-5, B-4, C-3
A-1, B-2, C-5

⇒ The function δ'(t - b) is a unit doublet.
TRUE
FALSE

⇒ Z = _______
C[A(B + C) + D]
(AB + AC + D)
(CA + AC + D)
none of these

⇒ The current gain of a BJT is
g_m r₀
g_m/r₀
g_m r_p
g_m/r_p

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ A piece of copper and another piece of Germanium are cooled from 30°C to 80 K. The resistance of
copper decreases and germanium increases
both decreases
both increases
copper increases and germanium decreases

⇒ The problem associated with tuned-radio frequency receiver is
instability
insufficient adjacent frequency rejection
bandwidth variation
all of the above

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
42.2 V
19.098 V
38.2 V
none of these

⇒ 2's complement of (-24) =
11101000
1001000
1111111
111111

⇒

Assertion (A): The access time of memory is lowest in the case of DRAM

Reason (R): DRAM uses refreshing cycle.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For a system with transfer funct
2.828
5.2915
5.088
cannot be determined

⇒ A(A + B) =
A
A B
AB
AB

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ In a radio receiver, if the intermediate frequency is too high
Selectivity will be poor
Tracking difficulties will be least
Adjacent channel rejection will improve
All of the above will occur

⇒ An accelerometer has a seismic mass of 0.05 kg and spring constant of 3 x 10⁵ N/m. If maximum displacement of mass is ± 1 mm, the maximum acceleration which can be measured is
30 m/s²
60 m/s²
90 m/s²
120 m/s²

⇒

Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR

Reason (R): Voltage across a capacitor can not change instantaneously.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a T flip-flop the output frequency is
same as input frequency
half of I/p frequency
double the input frequency
none

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ The circuit of figur
positive clipper
negative clipper
combination clipper
either (a) or (b)

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ Which of the following is not between F₂ layer and D layer?
E layer
F₁ layer
G region
All of the above

⇒ In a transistor E mode the collector current with the transistor in cut off region is
zero
high
equal to saturated value
none of the above

⇒ In rectifiers the use of RC filters is recommended when
load current is high
load current is small
load current is neither high nor small
either (a) or (c)

⇒ A potential difference is developed across a current carrying metal strip when the strip is placed in a transverse magnetic field. The above effect is known as
Fermi's effect
Photo electric effect
Joule's effect
Hall's effect

⇒ The magnitudes of OC and SC input impedances of a transmission line an 100 Ω and 25 Ω. The characteristic impedance is
25 Ω
50 Ω
75 Ω
100 Ω

⇒ An excitation is applied to a system at t = T and the response in zero for -∞ < t < T. This system is
non casual
stable
casual
unstable

⇒ The materials having low retentivity are suitable for making
temporary smagnets
weak magnets
permanent magnets
both temporary and permanent magnets