Question is ⇒ Shaft encoder is used to measure, Options are ⇒ (A) angular position, (B) linear position, (C) linear velocity, (D) linear acceleration, (E) , Leave your comments or Download question paper.

Question is ⇒ Shaft encoder is used to measure, Options are ⇒ (A) angular position, (B) linear position, (C) linear velocity, (D) linear acceleration, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Shaft encoder is used to measure
A.	angular position [Correct Answer]
B.	linear position [Wrong Answer]
C.	linear velocity [Wrong Answer]
D.	linear acceleration [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Assuming accumulator contain A 64 and the carry is set (1).What will register A and (CY) contain after RAR?
4 DH, 0
D 3H, 0
4 DH, 1
53 H, 0

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒

Assertion (A): In a parallel circuit having two branches, each branch current may be more than source current.

Reason (R): Calculations in ac circuits use rules of complex algebra.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which configuration is suitable for impedance matching?
CB
CE
CC
CB and CE

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒

Match the following:

	List I		List II
A.	Total instantaneous value of emitter current	1.	I_E
B.	Quiescent value of emitter current	2.	i_E
C.	Instantaneous value of as component of emitter current	3.	I_e
D.	RMS value of ac component of emitter current	4.	i_e

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ If Nyquist plot has a encirclement of (-1 + jo) point, the system is stable if
there are no poles of G(s) H(s) in right-half plane
there is one pole of G(s) H(s) in right-half plane
there is no zeros of G(s) H(s) in right-half plane
none of the above

⇒ Which one most appropriate dynamic system?
y(n) + y(n - 1) + y(n + 1)
y(n) + y(n - 1)
y(n) = x(n)
y(n) + y(n - 1) + y(n + 3) = 0

⇒ Which pair is correctly matched?
Symmetrical two port AD - BC = 1
Reciprocal two port z₁₁ = z₁₂
Inverse hybrid parameter A, B, C, D
hybrid parameter (V₁, I₂) = f(I₁, V₂)

⇒ Frequency band used for radar is generally
VLF
VHF
UHF
EHF

⇒ A current of 3.25 A is flowing through a resistance of 34.98 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.685 V
113.68 V
113.6 V
114 V

⇒ Equation x_l0 = 11001001₂ when solved for x gives the value of x as
8
111
152
201

⇒ Which of these are universal gates?
Only NOR
Only NAND
Both NOR and NAND
NOR, NAND, OR

⇒ What is the characteristic impedance at 10 MHz?
547.7 Ω
54.7 Ω
5.47 Ω
.547 Ω

⇒ Consider the following statements about mutual inductances:

The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease

⇒ For the discrete time system of the given fig
y_k = 0.5 u_{k - 2} - u_k - 0.25 y_k - 1
y_k = 0.5 u_k_{- 1} - u_k - 0.25 y_k - 1
y_k = 0.5 u_k - u_k_{- 1} - 0.25 y_k - 1
y_k = 0.5 u_k_{- 1} - u_k_{- 1} - 0.25 y_k - 1

⇒ Unlimited number of ICs 7490, 78492 and 7493 are available. Which of these could be used to build the dividse-by-60 circuit of fi
7490
7492
combination of 7490 and 7492
combination of 7492 and 7493

⇒ The units for electrochemical equivalent are
grams
grams per coulomb
gram-coulomb
grams per ampere

⇒ A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere.
equal and of same again
equal and of opposite sign
unequal and of same sign
unequal and of opposite sign

⇒ Which of the following circuits come under the class of combinational logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 only
3 and 4
4 and 5
1, 2 and 3

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ The transfer function of a discrete time LTI system is give
Both S1 and S2 are true
Both S2 and S3 are true
Both S1 and S3 are true
S1, S2 and S3 are all true

⇒ The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.02
0.005
0.0005

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light