Question is ⇒ The deflection of a DArsonval galvanometer is measured through a mirror and scale. The mirror is 1 m away from the light source. The mirror is mounted on, the moving system. If mirror rotates through 0.2 rad the displacement on the scale is, Options are ⇒ (A) 0.2 m, (B) 0.4 m, (C) 0.1 m, (D) 0.05 m, (E) , Leave your comments or Download question paper.

Question is ⇒ The deflection of a DArsonval galvanometer is measured through a mirror and scale. The mirror is 1 m away from the light source. The mirror is mounted on, the moving system. If mirror rotates through 0.2 rad the displacement on the scale is, Options are ⇒ (A) 0.2 m, (B) 0.4 m, (C) 0.1 m, (D) 0.05 m, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The deflection of a DArsonval galvanometer is measured through a mirror and scale. The mirror is 1 m away from the light source. The mirror is mounted on, the moving system. If mirror rotates through 0.2 rad the displacement on the scale is
A.	0.2 m [Wrong Answer]
B.	0.4 m [Correct Answer]
C.	0.1 m [Wrong Answer]
D.	0.05 m [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ Calculate the wave number in waveguide having dimensions 4 x 2 cm at 3 GHz
6.28
62.8
8
0

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ Which of the following is true as regards photo emission?
Velocity of emitted electrons is dependent on light intensity
Rate of photo emission is inversely proportional to light intensity
Maximum velocity of electron increases with decreasing wave length
Both holes and electrons are produced

⇒ Satellite communication systems use the frequency band
10 to 20 MHz
50 to 70 MHz
3 to 6 GHz
100 to 120 GHz

⇒ Leak type bias is used in a plate-modulated class C amplifier to
prevent tuned circuit damping
prevent over modulation
increase the bandwidth
prevent excessive grid current

⇒ In FM, as the modulating frequency decreases and the modulating voltage amplitude
increases, the modulation index increases
decrease, the modulation index increases
remains constant, the modulation index increases
remains constant, the modulation index decreases

⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ .
16 μs
15 ms
6.5 ms
66 ms

⇒ Which of the following is a passive component?
Semiconductor devices
Vacuum tube devices
Capacitors
All of the above

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ Good frequency stability can be available
crystal oscillators
Hartley oscillators
colpitts oscillators
none of the above

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ An electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis is
synchro control transformer
LVDT
stepper motor
tacho generator

⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
1.39 V
0.75 V
13.9 V
7.45 V

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b would always be in phase
V_a may lag or lead V_b

⇒ An ohmmeter is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒

Assertion (A): The carry look ahead adder is very fast

Reason (R): The carry look ahead adder generates the carry and sum digits directly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ 1 dB is equal to __________ nepier
8.6
6.8
8
0

⇒ The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
3.91 dB
1.95 dB
0.39 dB
0.195 dB

⇒ For an N-point FFT algorithm with N = 2^m which one of the following statements is TRUE?
It is not possible to construct a signal flow graph with both input and output in normal order
The number of butterflies in the m^th stage is N/m
In-place computation requires storage of only 2N node data
Computation of a butterfly requires only one complex multiplication

⇒ For a Gaussian process, auto-correlation also implies
statistical dependence
statistical independence
ergodic process
none of the above

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒

Assertion (A): Static RAMS are used where speed of operation is of primary concern.

Reason (R): Dynamic RAM has lower cost per bit than static RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I		List II
A.	Total instantaneous value of emitter current	1.	I_E
B.	Quiescent value of emitter current	2.	i_E
C.	Instantaneous value of as component of emitter current	3.	I_e
D.	RMS value of ac component of emitter current	4.	i_e

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

⇒ In a CD player the speed of CD is
constant at 500 rpm
constant at 200 rpm
varies from 200 to 500 rpm
none of the above