Question is ⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is, Options are ⇒ (A) 100 KHz, (B) 200 KHz, (C) 50 KHz, (D) 150 KHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is, Options are ⇒ (A) 100 KHz, (B) 200 KHz, (C) 50 KHz, (D) 150 KHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is
A.	100 KHz [Wrong Answer]
B.	200 KHz [Correct Answer]
C.	50 KHz [Wrong Answer]
D.	150 KHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒ The expression A² + B² - 3 AB when written is Pascal should be written as
A * A + B * B - 3 A * B
A * A + B * B - 3.0 A * B
A * A + B * B - 3.0 * A * B
A * A + B * A - 3 * A * B

⇒ Consider the following statements, SWR of a transmission line is infinite when the load is

a short circuit
a complex impedance
an open circuit
a pure reactance

Which of the above statements are correct?
1 and 3 only
1, 2, 3
2, 3, 4
1, 2, 4

⇒ A Read/Write memory chip has a capacity of 64 k bytes. Assuming separate data and address line and availability of chip enable signal, what is the minimum number of pins required in the IC chip?
28
26
24
22

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒

Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following closely represents the resistance-temperature characteristics of thermistor?
R_T = a R₀ e^b/t
R_T = a R₀ E^-b/t
R_T = - a R₀ e^-b/t
R_T = - R₀ e^b/t

⇒ The closing of switch S₁ and S₂ in figure will ligh
lamp L₁ only
lamps L₁ and L₂
none of them
lamp L₂ only

⇒ The effective length of an λ/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.13 λ² and η = 120 p is __________ .
0.6348 λ
0.317 λ
0.158 λ
0.371 λ

⇒ For a transistor to have-a larger β it must have and a
close to zero
close to 0.5
close to unity
nearly infinite

⇒

Assertion (A): If the resistance of shunt of an ammeter is increased, the range of ammeter is reduced.

Reason (R): If the series resistance of a voltmeter is increased, the range of voltmeter is increased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒ In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹⁰/ cm³ the electron concentration is
zero
10¹⁰/cm³
10⁵/cm³
1.5 x 10²⁵/cm³

⇒ Consider the following statements about loop antenna

It is suitable for direction finding application
It is a single turn or multiturn coil carrying RF current
The loop is surrounded by a magnetic field everywhere perpendicular to the loop

Which of the above statements are correct?
1 and 2 only
1 only
1, 2, 3
2 and 3 only

⇒ A current of 1 A in the coil of an iron cored electromagnet cause a flux density of 0.2.T. If the current is 2 A, B=
0.2 T
0.4 T
0.4 T or less
0.4 T or more

⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V

⇒ For the binary number 11101000, the equivalent hexadecimal number is
F 9
F 8
E 9
E 8

⇒ A variable reluctance type tachometer has 150 teeth on rotor. The counter records 13500 pulse/sec. The rotational speed is
4800 RPM
5400 RPM
6000 RPM
7200 RPM

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ Indium, aluminium, arsenic are all p type impurities.
TRUE
FALSE

⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?
line open circuited at far end
line terminated in Z₀
line short circuited at far end
line terminated in inductance

⇒

Match the following:

	List I (Location of characteristics roots)		List II (System characteristic)
A.	(- 1 + j), (- 1 - j)	1.	Marginally stable
B.	(- 2 + j), (- 2 - j), (2, j) (- 2, j)	2.	Unstable
C.	- j, j - 1, 1	3.	Stable

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒

Assertion (A): When the performance of a stable second order system is improved by a PID controller, the system may become unstable.

Reason (R): PID controller increases the order of the system to 3.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3