Question is ⇒ In a stop-and-wait ARQ system, the transmitting terminal, Options are ⇒ (A) waits for positive or negative acknowled-gement from the receiving terminal after sending a block, (B) sends another block if positive acknowledge is received through ACK character, (C) resends the previous block if negative acknowledgement is received through a NAK character, (D) does not wait for acknowledgement after sending a block, (E) , Leave your comments or Download question paper.

Question is ⇒ In a stop-and-wait ARQ system, the transmitting terminal, Options are ⇒ (A) waits for positive or negative acknowled-gement from the receiving terminal after sending a block, (B) sends another block if positive acknowledge is received through ACK character, (C) resends the previous block if negative acknowledgement is received through a NAK character, (D) does not wait for acknowledgement after sending a block, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a stop-and-wait ARQ system, the transmitting terminal
A.	waits for positive or negative acknowled-gement from the receiving terminal after sending a block [Wrong Answer]
B.	sends another block if positive acknowledge is received through ACK character [Wrong Answer]
C.	resends the previous block if negative acknowledgement is received through a NAK character [Wrong Answer]
D.	does not wait for acknowledgement after sending a block [Correct Answer]
View Answer 2 -7 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Let f(A, B) = A ⊕ B; then the simplified form of the function f(f(x ⊕ y, z)w) is
(x ⊕ y ⊕ z)w
x ⊕ y ⊕ z ⊕ w
(x ⊕ y ⊕ z) + w
none of these

⇒ The race condition in NOR SR latch occurs when
S = R = 1
S = 0, R = 1
S = 0, R = 0
S = 1, R = 0

⇒ In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒

Assertion (A): The main use of positive feedback is in oscillator circuits.

Reason (R): In an oscillator the loop gain Aβ is kept slightly more than unity

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The band gap of silicon at 300K is
1.36 eV
1.10 eV
0.80 eV
0.67 eV

⇒ For the circuit of the given figure, the output equatio
Y = ABCD
Y = AB + CD
Y = A + BCD
Y = ABC + D

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ In the circuit shown in the figure, the current supplied by the sinusoidal current source
28 A
0.166666666666667
20 A
not determinable from the data given

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ In oscillators class C operation is preferred because
is most efficient
has frequency stability
gives larger output
it produces nearly square waves

⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t²
t
t
1/t

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)

⇒ The life time of a geosynchronous communication
5
10
20
50

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic

⇒

Assertion (A): Gate triggering is the most commonly used method for triggering of an SCR.

Reason (R): Even a small gate current is sufficient to turn on an SCR.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ To measure a resistance of about 8 ohms we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (b) or (c)

⇒

Assertion (A): The forward dynamic resistance of p-n diode varies inversely with current.

Reason (R): The forward dynamic resistance of p-n diode varies with the operating voltage.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Indicate the false statement: If SWR on a transmission line is infinite, the line is terminated in
open circuit
short circuit
pure reactance
complex impedance

⇒ Consider the following statements:

In the 2's complement representation, negative numbers are stored in sign magnitude form.
Taking 2's complement is equivalent to sign change.
In a 4 bit complement representation of a binary number A.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.

Of these, the only true statements are
(I) and (III)
(I) and (IV)
(II) and (III)
(II) and (IV)

⇒ Which of the following are included in the architecture of a computer?

Addressing modes, CPU
Instruction set, data formats
Secondary memory, operating system

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
3 only

⇒

Match the following:

	List I (I/P - O/P relation)		List II (Property of the system)
A.	y(n) = x(n)	1.	Nonlinear, non-causal
B.	y(n) = x(n²)	2.	Linear, non casual
C.	y(n) = x²(-n)	3.	Linear causal
D.	y(n) = x²(n)	4.	Nonlinear causal

A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4
A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2

⇒ Consider the following DO statement in Fortran 77 1
11
10
4

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ Consider the following statements:

Strictly speaking C supports 1-dimensional arrays only.
An array element may be an array by itself.
Array elements need not occupy contiguous memory locations.

Which of the above statements is/are correct?
1 only
2 only
1 and 2
2 and 3

⇒

Assertion (A): Impatt diode can be used in both amplifiers and oscillators.

Reason (R): Impatt diode has a low resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be
9.76 V
1 μV
23.56 μV
6.94 μV

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒ In a simple on-off controller with differential gap, the magnitude of differential gap determines
the level of accuracy
the life of controller
both (a) and (b)
neither (a) nor (b)