Question is ⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ ., Options are ⇒ (A) decreases, decreases, (B) decreases, increases, (C) increases, decreases, (D) increases, increases, (E) , Leave your comments or Download question paper.

Question is ⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ ., Options are ⇒ (A) decreases, decreases, (B) decreases, increases, (C) increases, decreases, (D) increases, increases, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The ripple factor from a capacitor filter __________ as the load resistance __________ .
A.	decreases, decreases [Wrong Answer]
B.	decreases, increases [Correct Answer]
C.	increases, decreases [Wrong Answer]
D.	increases, increases [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A function f(t) = k is
stable
marginal stable
unstable
none

⇒ In TV transmitter some possible advantages of IF modulation are

The modulator section and visual exciter can be solid state devices
VSB filter can be introduced at low power level
The subsequent stages following VSB filter can be tuned permanently for wideband linear operation
It is economical

which of the above are true?
1 and 2
1, 2 and 3
2, 3 and 4
1, 2, 3 and 4

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ The reflection coefficient on a line is 0.2 ∠45°. The SWR is
0.8
1.1
1.2
1.5

⇒ Some features of RF stage in good radio receivers is

It increases sensitivity by providing amplification to RF signal
It eliminates image frequency interference
It increases selectivity
It reduces noise level

Which of the above are true?
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only
1, 2, 3, 4

⇒ Beamwidth of an antenna depends upon
shape of radiation pattern
dimensions
wavelength
all of the above

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
1 MΩ
100 kΩ
15 kΩ
≈ 0

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ The dc output voltage of the circui
4.3 V
1.369 V
3.87 V
1.94 V

⇒ Which of the following is used in temperature alarm circuits?
Thermistor
Photoconductor
Transistor
Varistor

⇒ Which of the following is not an application software?
MS Word
DBMS
Worksheet
Lisp

⇒ Present day HVDC converters are all
3 pulse converters
6 pulse converters
12 pulse converters
either 6 pulse or 12 converters

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
will increase
will decrease
will remain the same
may increase or decrease

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be
1.116
1.386
2.116
2.386

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ In log magnitude Bode diagram the slope of high frequency asymptote of (1 + jωT) is
20 dB per decade
10 dB per decade
20 dB per octave
10 dB per octave

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 076
0.3, 0.95

⇒ A single phase half wave rectifier circuit has a free wheeling diode. The free wheeling diode will conduct only if
load is purely resistive
load is purely inductive
load is combination of R and L
load is purely inductive or combination of R and L

⇒ Y = A + A B is the same as
Y = AB
Y = A + B
Y = A + B
Y = A + B

⇒ A colour monitor usign 16 bits at a resolution of 600 x 400 pixels needs a memory of
240000 B
9600 B
6400 B
480000 B

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ A linear time-invariant, causal continuous time system has a rational transfer function with simple poles at s = - 2 and s = - 4, and one simple zero at s = - 1. A unit step u(t) is applied at the input of the system. At steady state, the output has constant value of 1. The impulse response of this system is
[exp (- 2t) + exp (-4t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t) - exp (-t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t)] u(t)
[-0.5 exp (- 2t) + 1.5 exp (-4t)] u(t)

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A P-channel MOSFET operating in the enhancement mode is characterized by V_t = - 4 V and I_DQ = - 10 mA, when V_GSQ = - 5.5 V, what will be V_GSQ if I_DQ = -15 mA and I_{D, on} = - 16 mA
- 2 V
3 V
0.13 V
1.3 V

⇒ Consider the directive T : DS105. This directive
directs the assembler to reserve a sequence of 105 bytes in the memory
directs the assembler to reserve a sequence of 105 bits in the memory
directs the assembler to reserve a sequence of consecutive 105 bytes in the memory
directs the assembler to reserve a sequence of consecutive 105 bits in the memory

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. When the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒ A lag compensator
speeds up the transient response of the system
improves steady state behaviour of the system
improves steady state behaviour and speeds up the transient response of the system
improves steady state behaviour and preserves the transient response of the system