Question is ⇒ In a JFET the width of channel is controlled by, Options are ⇒ (A) gate voltage, (B) drain current, (C) source current, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a JFET the width of channel is controlled by, Options are ⇒ (A) gate voltage, (B) drain current, (C) source current, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a JFET the width of channel is controlled by
A.	gate voltage [Correct Answer]
B.	drain current [Wrong Answer]
C.	source current [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ 2's complement of (-24) =
11101000
1001000
1111111
111111

⇒ In shot noise
the current rises around mean value
the current rises to peak value, decreases to zero and then again rises
the current may become negative
the current is always less than the mean value

⇒ The polarities of the magnetised iron rod of
A is N, B is S and C is neutral
A is N, B is S and C is S
A is N, B is N and C is S
A is S, N is S and C is N

⇒ The electron and hole concentration in a intrinsic semiconductor are n_i and P_i respectively when doped with a P type material, these change to n and P, respectively. Then
n + P = n_i + P_i
n + n_i = P + P_i
nP_i = n_iP
n_P = n_i P_i

⇒ A linear diode detector uses RC filter. As modulation index increases the maximum permissible value of time constant RC
increases
decreases
remains constant
either (a) or (c)

⇒ For exponential function e^-at the Laplace transform 1/(s - a)
TRUE
FALSE

⇒ Decimal 45.15 when converted into 9's complement will become
54.84
45.48
48.54
45.84

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is
0
1
∞
2

⇒ The INTELSAT-IV satellite launched in 1974 had two earth coverage antenna and two narrower-angle antennas subtending 4.5°. The signal from narrow-angle antenna was stronger than that from earth- coverage antenna by a factor of
17.34/4.5
17.34 x 4.5
(17.34/4.5)²
(17.34/4.5)⁴

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒ Which of the following is not correct?
Voltmeter should have a very high resistance
An ammeter should have a very low resistance
A shunt should have a very low resistance
An electronic voltmeter draws appreciable current from source

⇒ In microwave communication links, when fading due to rain attenuation occurs then technique adopted for solving the problem would include
antenna replacement and feed correction
amplitude timing and phase correction
polarization shifting and code diversity
path diversity and frequency diversity

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?
Satellite communication
Ground propagation
Polarized communication
None of the above

⇒ An AND gate has four inputs. One of the inputs is low and other inputs are high. The output
is low
is high
is alternately low and high
may be high or low depending on relative magnitudes of inputs

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒ When a transistor is to be at a temperature above 25°C
smaller heat sink be provided
maximum power rating be derated
biasing circuit must be strengthened
earth connections must be connected through a resistor

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ While forming Routh's array, the situation of a row of zeros indicates that the system
has symmetrically located roots
is not sensitive to variations in gain
is stable
is unstable

⇒ A two-input OR gate is designed for positive logic. However, it is operated with negative logic. The resulting logic operation will then be
OR
AND
NOR
EX-OR

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
-0.6
-1
0.6
0

⇒ It is desired to clean up ragged looking pulsed that have been distorted during transmission from one place to another, which of the following device will be appropriate?
Multiplexer
D/A converter
JK flip-flop
Schmitt trigger

⇒ What is the length of SP (Stack pointer) of 8085 μp?
6 bits
8 bits
12 bits
16 bits

⇒ A voltage V(t) which is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt² is measured by a true rms meter. The reading will be
0
4
2
16

⇒ In figure the approximate voltage
base and emitter are - 8 V and - 7.3 V
base and collector are - 8 V and - 5 V
collector and emitter are - 5 V and - 7.3 V
base, emitter and collector are - 8, - 7.3 and - 5 V

⇒ The property not valid for basic singularity function is
it is even signal
convolution of any arbitrary function x{t) and an impulse is the original function itself.
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒ For the network shown below, determine f_Hi and f_HO, if, r₀ = ∞, C_be = 36 Pf, C_bc = 4 Pf, C_ce = 1 Pf, C_wo = 8 Pf, C_wi = 6 Pf<
738.24 KHz, 8.6 MHz
781.2 KHz, 10.6 MHz
838.32 KHz, 9.2 MHz
938.24 KHz, 8.2 MHz

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math