Question is ⇒ Which chopper circuit uses saturable reactor?, Options are ⇒ (A) Auxiliary commutated, (B) Jones chopper, (C) Morgan chopper, (D) Load commutated, (E) , Leave your comments or Download question paper.

Question is ⇒ Which chopper circuit uses saturable reactor?, Options are ⇒ (A) Auxiliary commutated, (B) Jones chopper, (C) Morgan chopper, (D) Load commutated, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which chopper circuit uses saturable reactor?
A.	Auxiliary commutated [Wrong Answer]
B.	Jones chopper [Wrong Answer]
C.	Morgan chopper [Correct Answer]
D.	Load commutated [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A specimen of a material has a resistivity of 1.78 x 10⁸ ohm-m. The material is
semiconductor
conductor
semiconductor or conductor
insulator

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒ Saturation of iron core causes distortion.
TRUE
FALSE

⇒ A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is a. During one cycle of input voltage, the total duration of conduction of freewheeling diode is
a
2 a
4 a
0.5 a

⇒ Electronic tubes used for transmitter differ from their counterparts in the receivers in respect that
they are large in size
they are capable of handling large powers
they generate large amount of heat when in operation
none of the above

⇒ Which inverter circuit uses coupled inductors?
Modified McMurray full bridge inverter
McMurray Bedford half bridge inverter
Modified McMurray Bedford half bridge inverter
Both (b) and (c)

⇒
Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.
Reason (R): In a symmetrical matrix S_ij = S_ji.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒
Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops
Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ A discrete LTI system is non-casual if its impulse response is
aⁿ ∪(n - 2)
a^n-2 ∪(n)
aⁿ⁺² ∪(n)
aⁿ ∪(n + 2)

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ Find R_L for maximum power trans
3 Ω
1.125 Ω
4.1785 Ω
None of these

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ Short circuit is the dual of open circuit.
TRUE
FALSE

⇒ Noise which assumes great importance at high frequencies is
flicker noise
Johnson noise
transit-time noise
shot noise

⇒ In the vacuum diode equation i_b = ke_b^1.5, the current is
temperature limited current
space charge limited current
any of the above
none of the above

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ Which of the following is not a valid real variable in FORTRAN 77?
ANUT
MONEY
A MONEY
BS

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ To obtain very high input and O/P impedance in a feedback amplifier, the type of feedback utilized
voltage series
current series
voltage shunt
current shunt

⇒ E-mail can be used to send text, graphics, and video.
TRUE
FALSE

⇒ Acoustic strain gauges
have good linearity of measurement
do not have long term stability
have a large range of measurement
have an accuracy range of 0.1-1% depending on environment

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒
Assertion (A): The Fourier series of the wave shown in the figure does not contain even harmao
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math