Question is ⇒ The output of the circuit shown below will be of the frequ, Options are ⇒ (A) 125 Hz, (B) 250 Hz, (C) 500 Hz, (D) 750 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ The output of the circuit shown below will be of the frequ, Options are ⇒ (A) 125 Hz, (B) 250 Hz, (C) 500 Hz, (D) 750 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The output of the circuit shown below will be of the frequ
A.	125 Hz [Wrong Answer]
B.	250 Hz [Correct Answer]
C.	500 Hz [Wrong Answer]
D.	750 Hz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ A Yagi antenna has a driven antenna
only
with a reflector
with one or more directors
with a reflector and one or more directors

⇒ A photoconductor is a
conductor
semiconductor
insulator
superconductor

⇒ Which junction transistor is preferred for high input and low output impedances?
Common emitter
Common base
Common collector
Any of the above

⇒ In PCM, the biggest disadvantage as compared to AM is
larger bandwidth
larger noise
inability to handle analog signals
incompatibility with time division multiplex systems

⇒ In which n type device does p substrate extend upto silicon dioxide layer?
JFET
Depletion type MOSFET
Enhancement type MOSFET
Both (b) and (c)

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction

⇒ The static electric field in a conductor is
zero
unity
infinity
none of the above

⇒ In a J-K FF we have J = Q and K = 1. Assuming the FF was initially cleared and then clocked for 6 pulses, the sequence at the Q output wil
10000
11001
10010
10101

⇒ In a Weston synchronoscope, the moving coil is connected across
bus bar
incoming alternator
lamp
fixed coils

⇒ For an RC driving point impedance function, the poles and zeros
should alternate on real axis
should alternate only on negative real axis
should alternate on imaginary axis
none of the above

⇒ DMA stands for
Direct Memory Address
Distributed Memory Address
Direct Memory Accumulator
Decimal Machine Address

⇒ In intrinsic semiconductor the increase in conductivity per degree increase in temperature is about
0.02
0.06
0.15
0.25

⇒ For insulators the energy gap is of the order of
0.1 eV
0.7 eV
1.1 eV to 1.2 eV
5 to 15 eV

⇒ The polarities of the magnetised iron rod of
A is N, B is S and C is neutral
A is N, B is S and C is S
A is N, B is N and C is S
A is S, N is S and C is N

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be
24.09 MHz
24.54 MHz
25.45 MHz
25.91 MHz

⇒ Which of the following is invariably found in SSB?
Tuned modulator
Class B, RF amplifier
Class C, audio amplifier
All of the above

⇒ The maximum distance between television transmission and receiving antennas for reasonably good reception should be
less than 20 km
less than 100 km
less than 500 km
less than 1000 km

⇒ In operational Amplifier, Common mode voltage gain should be
0
∞
1
0.5

⇒ The power requirements of a DRAM in active and stand by modes is about
350 mW and 5 mW respectively
350 mW each
5 mW each
350 mW and 100 mW respectively

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ The band gap of silicon at 300K is
1.36 eV
1.10 eV
0.80 eV
0.67 eV

⇒ In the given figure
A
B
A + B + C
ABC

⇒ The Boolean function realized by the logic circuit show
F = Σm(0, 1, 3, 5, 9, 10, 14)
F = Σm(2, 3, 5, 7, 8, 12, 13)
F = Σm(1, 2, 4, 5, 11, 14, 15)
F = Σm(2, 3, 5, 7, 8, 9, 12)

⇒ If X = - 285.56 and the Pascal write statement used is WRITE (X : 8). Then the print out will appear as
-285.56
-2.85 E + 02
-2.85560 E + 02
-2.8 E + 02

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above

⇒

Assertion (A): Many times a radar cannot detect 'grounding hopping' military aircraft.

Reason (R): Ground interference limits the range of radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Schrodinger wave equation is partial differential equation.
TRUE
FALSE

⇒

Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal.

Reason (R): Emitter base junction in BJT is forward biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The expression for satellite link frequencies such as 4/6 GHz denotes that
4 GHz is the up-link and 6 GHz is the down-link frequency
4 GHz is the down-link and 6 GHz is the up-link frequency
the system operates at a mean frequency of 5 GHz
one frequency is used as a back up for the other