Question is ⇒ Which one of the following is non-resonant antenna?, Options are ⇒ (A) Folded dipole, (B) Broad side array, (C) End fire array, (D) Rhombic antenna, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is non-resonant antenna?, Options are ⇒ (A) Folded dipole, (B) Broad side array, (C) End fire array, (D) Rhombic antenna, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is non-resonant antenna?
A.	Folded dipole [Wrong Answer]
B.	Broad side array [Wrong Answer]
C.	End fire array [Wrong Answer]
D.	Rhombic antenna [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be
10 V
12.5 V
14.1 V
15 V

⇒ For most static RAM the write pulse width should be at least
10 ns
60 ns
300 ns
1 μs

⇒ The measurement of Hall coefficient of a semiconductor with one type of charge carriers gives the information about
sign of charge carrier
density of charge carrier
both sign and density of charge carrier
none of the above

⇒ In Intel 8085, the integer range per word length is
-128 to 127
-127 and 128
-64 and 63
-63 and 64

⇒ In a AM wave the carrier and one of the side bands is suppressed. If m = 0.5, the percentage saving in power is
0.5
0.833
0.944
1

⇒

Assertion (A): In rectangular waveguide TE₀₁ mode is just TE₁₀ mode rotated by 90°.

Reason (R): When a rectangular waveguide is rotated by 90°, the broad and narrow dimensions get interchanged.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Frequency shifting keying is basically a method involving
amplitude modulation
frequency modulation
phase modulation
none of the above

⇒ In a bridge inverter with single pulse width modulation
the output frequency is equal to frequency of reference signal
the output frequency is equal to frequency of control signal
either (a) or (b)
neither (a) nor (b)

⇒ The network has 10 nodes and 17 branches. The number of different node power voltages would be
7
9
10
45

⇒ The hexadecimal number 64 AC is equivalent to decimal number
25727
25722
25772
25777

⇒ The converter whose conversion time is independent of number of bits is
dual stope
counter type
parallel conversion
successive approximation

⇒ Which of following is recursive system?
y(n - 1)
y(n + 1)
y(n)
y(n) + y(n + 1)

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa

⇒ A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
83.33 μ sec
1 μ sec
0.1 m sec
3.5 m sec

⇒ The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
3.91 dB
1.95 dB
0.39 dB
0.195 dB

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒ A conductor in x-y plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m² is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these

⇒

Match the following:

	List I		List II
A.	Electro-encephalograph	1.	Diagnostic tool for heart ailment
B.	Electro-cardiograph	2.	Diagnostic tool for brain ailment
C.	Sphygmomanometer	3.	used for measuring BP
D.	Stethoscope	4.	used to heart pulse/ heart beat

A-2, B-1, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-1, C-4, D-3
A-1, B-2, C-3, D-4

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ In a digital counter the number of flip-flops is
always 2
always even
always odd
equal to the number of bits required in the final binary count

⇒ The output of a half adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒

Assertion (A): Transformer coupling has the disadvantage of the weight of transformer and Saturation of core

Reason (R): Transformer coupling is very suitable for impedance matching

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ Which power amplifier can deliver maximum load power?
Class A
Class AB
Class B
Class C

⇒ A total of 16 equally probable events exist. If it is required to select one out of them, the number of required bits is
2
4
3
5

⇒ TTL uses
multi-emitter transistors
multi-collector transistors
multi-base transistors
multi-emitter or multi-collector transistors

⇒ The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.
540
270
135
1080