Question is ⇒ For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give, Options are ⇒ (A) A + (B + C) D, (B) A + BC + D, (C) A(BC + D), (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give, Options are ⇒ (A) A + (B + C) D, (B) A + BC + D, (C) A(BC + D), (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give
A.	A + (B + C) D [Wrong Answer]
B.	A + BC + D [Wrong Answer]
C.	A(BC + D) [Correct Answer]
D.	none of these [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a sequential circuit the output at any instant depends on
present inputs only
past inputs only
past outputs only
past output and present input

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The frequency range for satellite communication is
3 to 30 kHz
300 to 3000 kHz
3000 to 30000 MHz
30000 to 300000 MHz

⇒ In broadside array
the principle direction radiation is perpendicular to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and perpendicular to the plane containing the array elements
the principle direction radiation is perpendicular to the array axis and parallel to the plane containing the array elements

⇒ If we connect two silicon unilateral switches in anti- parallel we get
SCR
SBS
SCS
UJT

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
13 mm
1.3 mm
130 mm
none of the above

⇒ The more negative gate voltage, the conductive channel becomes
narrower
wider
thicker
linear

⇒ For parallel RLC circuit, which one of the following statements is NOT correct?
The bandwidth of the circuit deceases if R is increased
The bandwidth of the circuit remains same if L is increased
At resonance, input impedance is a real quantity
At resonance, the magnitude of input impedance attains its minimum value

⇒ Read the following statement

Multi-processing operation permits highly efficient parallel processing at several levels.
Multi processing involves use of several processing units jointly on a common program and severally on different programs.
In multi-processing the assignment of facilities to tasks, loading of programs and monitoring of I/O activity is taken care of by operating system.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The maximum range of a radar is proportional to
square root of peak transmitted pulse power
fourth root of peak transmitted pulse power
peak transmitted pulse power
none of the above

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ How many interrupts are there in 8085 microprocessor?
4
5
6
8

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ The analog signal m(t) is given below m(t) = 4 cos 100 pt + 8 sin 200 pt + cos 300 pt, the Nyquist sampling rate will be
1/100
1/200
1/300
1/600

⇒ The dominant mode in a rectangular wave-guide is
TE₀₁
TM₀₁
TE₁₀
TM₁₁

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒

Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following statements about conditions that make a metal semiconductor contact rectifying

N type semiconductor with work function φ_s more than work function φ_M of metal
N type semiconductor with work function φ_s less than work function φ_M of metal
P type semiconductor with work function φ_s more than work function φ_M of metal
P type semiconductor with work function φ_s less than work function φ_M of metal.

Of these statements
1 and 3 are correct
2 and 3 are correct
1 and 4 are correct
2 and 4 are correct

⇒ In a CE transistor amplifier, when collector-emitter voltage increases
the instantaneous operating point moves up the load line
the instantaneous operating point moves down the line
load current increases
none of the above

⇒ Secondary emission results
when temperature of metals is raised to a level above the crystallization temperature
when metals are subjected to strong magnetic fields
when light rays fall on the metal surface
when a high velocity beam of electrons strikes as metal surface

⇒ The poles of an RC function
are simple and lie on jω axis
are simple and lie on negative real axis
may be complex conjugate
may be anywhere in s plane

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ A metal loses electrons at room temperature.
TRUE
FALSE

⇒ A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
220 V
200 V
198 V
0 volts

⇒ A complementary symmetry amplifier has
1 P-N-P and 1 N-P-N transistor
2 P-N-P transistor
2 N-P-N transistor
2 P-channel FETs

⇒ In figure, V_{020 V
10 V
5 V
0}