Question is ⇒ Data can be changed from spatial code to temporal code and vice-versa by using, Options are ⇒ (A) ADC and DAC, (B) shift Register, (C) synchronous counter, (D) timers, (E) , Leave your comments or Download question paper.

Question is ⇒ Data can be changed from spatial code to temporal code and vice-versa by using, Options are ⇒ (A) ADC and DAC, (B) shift Register, (C) synchronous counter, (D) timers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Data can be changed from spatial code to temporal code and vice-versa by using
A.	ADC and DAC [Wrong Answer]
B.	shift Register [Correct Answer]
C.	synchronous counter [Wrong Answer]
D.	timers [Wrong Answer]
View Answer 1 -6 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ Pre-emphasis and De-emphasis is done by using R-C circuit.
TRUE
FALSE

⇒ Assuming V_{CE sat} = 0.2 V and β = 50, the minimum base current (I_B) required to drive the transistor in the given figure to saturatio
56 μA
140 μA
60 μA
3 μA

⇒ For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives
h₁₂
y₁₂
h₂₁
y₂₁

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ Zener diode is invariably used with
forward bias
reverse bias
either (a) or (b)
zero bias

⇒ Consider the following statements about constants in 8085

The assembler treats 64 H as hexadecimal constant.
The assembler treats 154 as binary constant.
The assembler treats 540 as octal constant.
The assembler treats 138 as decimal constant.

Which of the above are correct?
1, 2 and 3 only
1, 3 and 4 only
1 and 3 only
2 and 4 only

⇒ For a NPN bipolar transistor, what is the main stream of current in the base region?
Drift of holes
Diffusion of holes
Drift of electrons
Diffusion of electrons

⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ In a Hurwitz polynomial
all coefficients are non-negative
the coefficients may be positive or negative
all coefficients are negative
all coefficients are non-negative and all zeros should be either in left half plane or simple on the imaginary axis

⇒ In the transformer shown in the figure, the inductance measured across the terminal 1 and 2 was 4 H with open terminals 3 and 4. It was 3H when the terminals 3 and 4 were short circuited. The coefficient of coupling woul
1
0.707
0.5
indetermine due to insufficient data

⇒ In the given figure power meters at A and B indicate 1 mW and 110 μW respectively. VSWR of lin
1.5
2
2.5
3

⇒

Match the following:

	List I		List II
A.	Coastals receiver	1.	VSB
B.	Stereo-multiplexing	2.	Demodulating DSB-SC
C.	TV broad casting	3.	FM radio broad casting
		4.	Slope overload
		5.	Matched filter

A-1, B-3, C-2
A-2, B-3, C-1
A-2, B-1, C-4
A-4, B-3, C-1

⇒ In the human eye, an image persists for a time of about
1 second
0.1 second
0.05 second
0.02 second

⇒ Which of the following has highest conductivity?
Silver
Aluminium
Tungsten
Platinum

⇒ A system is stable if ROC
include the unit circle
exclude the unit circle
lies on Circle
entire plane

⇒ In a J-K FF we have J = Q and K = 1. Assuming the FF was initially cleared and then clocked for 6 pulses, the sequence at the Q output wil
10000
11001
10010
10101

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length

⇒

Match the following:

	List I (Oscillator)		List II (Features)
A.	Wien Bridge	1.	RF oscillator, uses two inductors and one capacitor
B.	Colpitt's	2.	LC oscillator for radio frequencies uses three capacitances and one inductance
C.	Hartley	3.	RC oscillator for audio frequencies
D.	Clapp	4.	RF oscillator, uses two capacitances and one inductance

A-2, B-1, C-4, D-3
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ At high frequencies the output circuit of transistor amplifier reduces to
a lead network
a lag network
either (a) or (b)
neither (a) nor (b)

⇒ A data signal having frequency components from dc to 50 Hz is to be sent through pulse code modulation using an 8 digit code. The minimum carrier channel bandwidth is
1 kHz
2 kHz
4 kHz
8 kHz

⇒ The circuit in figur
rectifier
voltage to frequency converter
frequency to voltage converter
logarithmic amplifier

⇒ In force current analogue, mechanical mobility is analogous to
impedance Z
admittance Y
reactance X
conductance G

⇒ In a CD, the depth and width of each pit is
0.5 μm each
0.5 μm and 1 mm respectively
1 μm and 0.5 mm respectively
1 μm each

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar

⇒ The most frequent users of long distance VLF transmission is
ship communication
radio broadcasting
TV broadcasting
telephone and telegraph