Question is ⇒ - <i>ve</i> feedback in an amplifier, Options are ⇒ (A) reduces gain, (B) increase frequency and phase distortion, (C) reduce bandwidth, (D) increase noise, (E) , Leave your comments or Download question paper.

Question is ⇒ - <i>ve</i> feedback in an amplifier, Options are ⇒ (A) reduces gain, (B) increase frequency and phase distortion, (C) reduce bandwidth, (D) increase noise, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	- ve feedback in an amplifier
A.	reduces gain [Correct Answer]
B.	increase frequency and phase distortion [Wrong Answer]
C.	reduce bandwidth [Wrong Answer]
D.	increase noise [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is
10 Ω
(6.9 + j 7.24) Ω
(1.75 + j 3.098) Ω
(2 - j 5) Ω

⇒ A universal shift register can shift
from left to right
from right to left
both from left to right and right to left
none of the above

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ For an RC admittance function Y,
Y(∞) < Y(0)
Y(0) < Y(∞)
Y (∞) may be lesser or greater than Y(0)
Y(∞) = Y(0)

⇒ The directive gain of a transmitting antenna is proportional to
its cross-sectional area
square of cross-sectional area
square root of cross-sectional area
cube root of cross-sectional area

⇒ Holes act like
positive charges
neutral atoms
negative charges
crystals

⇒

Assertion (A): Hollow waveguides are frequently used as transmission lines at microwave frequencies.

Reason (R): Waveguide has high power handling capacity, low loss and simple structure.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Special circuits using neon tubes, contact relays and capacitors are used in many domestic appliances. The role of capacitor in figure i
reduce power loss
function as resistor when relay is on
delay the operation of the contact relay after switching on
open circuit the relay terminals

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ Point out the false statement
impulse noise voltage does not depend on bandwidth
thermal noise is independent of frequency at which it is measured
industrial noise is mostly of impulse type
space noise is observable at frequencies in the range of 8 MHz and higher

⇒ For what positive value of K does the polynomial s⁴ + 8s³ + 24s² + 32s + K have roots with zero real parts?
10
20
40
80

⇒ A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is a. During one cycle of input voltage, the total duration of conduction of freewheeling diode is
a
2 a
4 a
0.5 a

⇒ In the given figure the reflected current wave after first reflectio
0.18 A
-0.18 A
0.3 A
-0.3 A

⇒ Laplace transform method enables us to find the response in
steady state
transient state
both steady and transient state
transient state provided forcing functions do not exist

⇒ Multiplexer can be used as logic function generator.
TRUE
FALSE

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ An ac voltage 20 sin 1000t feeds an R-C series circuit. R = 8 Ω and active power is 4 W. The power factor is
1
0.8
0.6
0.4

⇒ In an n channel JFET
I_D, I_S and I_G are considered positive when flowing into the transistor
I_D and I_S are considered positive when flowing into transistor and I_G is considered positive when flowing out of it
I_D, I_S, I_G are considered positive when flowing out of transistor
I_S and I_G are considered positive when flowing into transistor and I_D is considered positive when flowing out of it

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒ A rare gas has N atoms per m³. If electronic polarizability of single atom of this gas is a_e, then
∈_r = Na_e
∈₀∈_r = Na_e
∈₀(∈_r - 1) = Na_e
∈₀(∈_r - 2) = Na_e

⇒ In pulse code modulation, if the signal is sampled at the rate of f and the number of pulses in one code group is p, then the number of pulses per second will be
p/f
f/p
1/pf
pf

⇒ In a klystron amplifier the input cavity is called
buncher
catcher
Pierce gun
collector

⇒ Which of the following is not a wideband antenna?
Marconi
Discone
Helical
Folded dipole

⇒ Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded t
the output wave is distorted
the output wave is under modulated
the modulation index is 100%
the modulation index is 50%

⇒ A thermometer requires 1 minute to indicate 98% of its final response to a step input. If it is a first order system the time constant is
1 minute
0.5 minute
0.25 minute
0.1 minute

⇒

Match the following:

	List I (Bit Pattern)		List II (Register pairs)
A.	00	1.	SP
B.	01	2.	B-C
C.	10	3.	D-E
D.	11	4.	H-L

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1

⇒ Which of the following Boolean algebra rules is correct?
A . A = 1
A + AB = A + B
A + A B = A + B
A(A + B) = B

⇒ Two passive elements are connected in series and a dc voltage is applied to the circuit. The time variation of the current is shown in figure. The two elements
one resistance and the other inductance
both resistances
one inductance and the other capacitance
one resistance and the other capacitance