Question is ⇒ Transistor T1 operates at 30 kHz and T2 operates at 300 Hz. The flicker noise is, Options are ⇒ (A) not depend on frequency, (B) T1 > T2, (C) T1 = T2, (D) T1 < T2, (E) , Leave your comments or Download question paper.

Question is ⇒ Transistor T1 operates at 30 kHz and T2 operates at 300 Hz. The flicker noise is, Options are ⇒ (A) not depend on frequency, (B) T1 > T2, (C) T1 = T2, (D) T1 < T2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
A.	not depend on frequency [Wrong Answer]
B.	T₁ > T₂ [Wrong Answer]
C.	T₁ = T₂ [Wrong Answer]
D.	T₁ < T₂ [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In TV system in India IF video and IF audio frequencies are
33.4 and 28.4 MHz respectively
38.9 and 33.4 MHz respectively
43.8 and 38.9 MHz respectively
33.4 and 38.9 MHz respectively

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ If the characteristic equation of a closed loop system is s² + 2s + 2, then the system is :
over damped
critically damped
under damped
undamped

⇒ Bipolar IC memories are fabricated using
high density versions of MOSFET or low density versions of bipolar transistor flip-flop.
high density version of MOSFET or bipolar transistor flip-flop
low density versions of MOSFETs
high density versions of the bipolar transistor flip-flop.

⇒ The circuit diagram shown in the figure consists of transistors
parallel connection
cascade connection
darlington connection
series connection

⇒ In p mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to
one pole/cycle
two pole/cycle
four pole/cycle
six pole/cycle

⇒ In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?
TE₀₁
TE₁₁
TE₀₅
TE₂₁

⇒ In the case of the circuit shown in the figure, the collector current I_C will be, if β = 100, V_BE = 0.7 V, I_CO = 0.1 βA at 20&d
2.26 mA
1.85 mA
0.357 mA
0.185 mA

⇒ Calculate the O/P voltage of a non-inverting constant gain multiplier with R₁ = 100 kΩ, R_f= 600 kΩ, V₁ = 2 volt, then O/P voltage V_o of non inverting op-amp is given by
16 V
14 V
20 V
15 V

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ A short vertical grounded antenna is required to radiate at 1 MHz. The effective height of the antenna is 302 m. The calculated value of radiation resistance is
1.58 Ω
158 Ω
15.8 Ω
none

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a backward wave oscillator the wave travelling along the line winds itself back and forth
TRUE
FALSE

⇒ If e = 110 sin (ωt + p/3) and i = 5 sin (ωt - p/3), the impedance of the circuit is
22 Ω
16 Ω
30.8 Ω
11 Ω

⇒ A coil is wound having a diameter d. Its inductance is 10 mH. If it is rewound on the same core with a wire having diameter 0.5 d and total weight of the wire is the same as before, the inductance will be
5 mH
10 mH
160 mH
40 mH

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ In figure, V_EB = 0.6 V, β = 99. Then V_C and I_C
9.3 V and 1.98 mA respectively
4.6 V and 1.98 mA respectively
9.3 V and 0.02 mA respectively
4.6 V and 0.02 mA respectively

⇒ In a commercially available good power supply the voltage regulation is about
0.01
0.05
0.1
0.2

⇒

Assertion (A): PIN diode can be used as attenuator and limiter.

Reason (R): PIN diode has a thin intrinsic layer.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): Most PCs use static RAM for main memory.

Reason (R): Static RAM is faster than dynamic RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ Which one of the following is a passive device/Component?
Transformer
Oscillator
Generator
None

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ In the given figure the reflected voltage wave after first reflectio
18 V
-18 V
30 V
-30 V

⇒ Which is a digital coding technique?
PCM
DM
DPCM
All

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒ If N bits are lumped together to get an N-bit symbol, the possible number of symbols is
2^N
2^{N - 1}
2^{N - 2}
2^{N - 4}

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ Read the following statements about sets

If A and B are sets then A + B denotes union of sets A and B.
The union of A and B is that set whose elements are in either A or B or both.
If A and B are sets, then difference of sets A and B is denoted by A - B.
A - B in the set obtained by removing elements of A from B.

Which of the above are true?
All
1, 2 and 3 only
2 and 3 only
1 and 4 only