Question is ⇒ FORTRAN expression for 3b2-5a2 is, Options are ⇒ (A) SQRT (3 * B ** 2 - 5 * A ** 2), (B) SQRT 3 * B ** 2 - 5 * A ** 2, (C) SQRT (3 * b ** 2 - 5 * a ** 2), (D) SQRT (3 * B ** 2) - SQRT (5 * A **2), (E) , Leave your comments or Download question paper.

Question is ⇒ FORTRAN expression for 3b2-5a2 is, Options are ⇒ (A) SQRT (3 * B ** 2 - 5 * A ** 2), (B) SQRT 3 * B ** 2 - 5 * A ** 2, (C) SQRT (3 * b ** 2 - 5 * a ** 2), (D) SQRT (3 * B ** 2) - SQRT (5 * A **2), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	FORTRAN expression for 3b²-5a² is
A.	SQRT (3 * B ** 2 - 5 * A ** 2) [Correct Answer]
B.	SQRT 3 * B ** 2 - 5 * A ** 2 [Wrong Answer]
C.	SQRT (3 * b ** 2 - 5 * a ** 2) [Wrong Answer]
D.	SQRT (3 * B ** 2) - SQRT (5 * A **2) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of following antenna produces elliptical polarisation?
Helical
Parabolic
Dipole
None

⇒ In figure V_CE (sat) = 0.1 V. Then I_C (sa
10 mA
20 mA
30 mA
40 mA

⇒ Polystyrene has a relative permittivity of 2.7. If the wave is incident at an angle θ_i of 30° from air into polystyrene, the angle of transmission will be nearly
0.2°
2°
18°
48°

⇒ The method of frequency compensation in moving iron voltmeter is
to use a capacitor in series with coil
to connect a capacitor in parallel with coil
to connect a capacitor in parallel with series resistance
none of the above

⇒ In figure the zener cur
is always 130 mA
may vary between 10 mA and 130 mA
may vary between 60 mA and 130 mA
is always equal to 65 mA

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ Conductivity σ, mobility μ and Hall coefficient K_H are related as
μ = σK_H
σ = μK_H
K_H = μσ
K_H =(μσ)^1.1

⇒ Which of following is linear and bilateral parameter?
Resistors
Semi conductor diodes
Electron tubes
Transistor

⇒

Match the following:

	List I		List II
A.	Darlington amplifier	1.	A circuit using pnp and npn transistors
B.	CB amplifier	2.	A CS amplifier driving a CG amplifier
C.	Cascade amplifier	3.	A circuit with over-all voltage gain close to 1 and very large input impedance
D.	Complementary symmetry amplifier	4.	A circuit with low input impedance

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒ In N-type semiconductor
electrons are majority carriers while holes are minority carriers
electrons are majority carriers while holes are majority carriers
both electrons as well as holes are majority carriers
both electrons as well as holes are minority carriers

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ A TV receiver has 20 kV EHT supply and total beam current (for 3 electron guns) of 1500 μA. The power handled by IHVT is
3 W
30 W
300 W
0.3 W

⇒ For the time domain response shown in figure the
lies on negative real axis
lies on positive real axis
lies on imaginary axis
is complex or imaginary

⇒ Load Z_L for maximum power transfe
R
R + jωL
R - jωL
none

⇒ Principle of superposition is applicable to
linear systems only
nonlinear systems only
both linear and non linear system
linear systems and some nonlinear systems

⇒ A presettable counter with 4 flip flops can start counting from
0
1000
any number from 0000 to 1000
any number from 0000 to 1111

⇒ The correct sequence of parts in klystron amplifier are
anode, catcher cavity, cathode, buncher cavity
cathode, buncher cavity, catcher cavity, cavity
anode, buncher cavity, catcher cavity, cathode
cathode, catcher cavity, anode, buncher cavity

⇒ The reflection coefficient on a line is 0.2 ∠45°. The SWR is
0.8
1.1
1.2
1.5

⇒

Assertion (A): Points in the s plane at which function G(s) is not analytic are called singular, points.

Reason (R): Singular points at which the function G(s) or its derivative approach infinity are called poles.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A quarter wave line open circuited at far end behaves as
inductance
L and C in parallel
capacitance
L and C in series

⇒ A voltage wave having 5% fifth harmonic content is applied to a series RC circuit. The percentage fifth harmonic content in the current wave will be
0.05
more than 5%
less than 5%
equal or more than 5%

⇒ The poles and zeros of a positive real function
may lie any where in s plane
may have positive or negative real part
must occur in conjugate pair
must have either negative or zero real part

⇒ For a periodic waveform, the power spectral density and correlation function form
a Laplace transform pair
a Fourier transform pair
either (a) or (b)
neither (a) nor (b)

⇒ A balun provides an impedance transformation of
0.667361111111111
0.334027777777778
0.167361111111111
0.0840277777777778

⇒ For TM waves in a parallel plate waveguide, the minimum attenuation arising from imperfect conductors would occur at a freq. of (f_c is the cut off frequency)
3 f_c
3 f_c
2 f_c
2 f_c

⇒ In communication receivers the fidelity is provided by
audio stage
detector range
mixer stage
all of the above

⇒ Capture effect occurs in
AM
FM
PCM
QAM

⇒ The instruction LDA 20 in 8085 means
contents of memory location 20 are fetched into the accumulator
the value 20 is fetched into accumulator
either (a) or (b)
neither (a) nor (b)