Question is ⇒ At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves, Options are ⇒ (A) open circuit, (B) short circuit, (C) pure resistor of value R, (D) pure resistor of value much higher than R, (E) , Leave your comments or Download question paper.

Question is ⇒ At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves, Options are ⇒ (A) open circuit, (B) short circuit, (C) pure resistor of value R, (D) pure resistor of value much higher than R, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves
A.	open circuit [Wrong Answer]
B.	short circuit [Wrong Answer]
C.	pure resistor of value R [Wrong Answer]
D.	pure resistor of value much higher than R [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a shift left register, shifting a bit by one bit means
division by 2
multiplication by 2
subtraction of 2
None of the above

⇒ Capture effect occurs in
AM
FM
PCM
QAM

⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be
18 kV
1.001 kV
6 kV
36 kV

⇒ LVDT is a
pressure transducer
displacement transducer
velocity transducer
acceleration transducer

⇒ In a 7 segment display, LEDs b and c lit up. The decimal number displayed is
9
7
3
1

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ A communication channel with AWGN operating at a signal to noise ratio SNR >> 1 and bandwidth B has capacity C₁. If the SNR is doubled keeping B constant, the resulting capacity C₂ is given by
C₂ ≈ 2C₁
C₂ ≈ C₁ + B
C₂ ≈ C₁ + 2B
C₂ ≈ C₁ + 0.3B

⇒ Equipment using BCD numbers
pocket calculators
electronic counter
digital voltmeters
all of the above

⇒ If a short line is terminated in characteristic impedance it behaves as an infinite line.
TRUE
FALSE

⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0
e^as F(s)
e^-as F(s)
- e^as F(s)
- e ^-as F(s)

⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ For an m x n matrix A, the eigen values are the roots of the characteristic equation
|I - A|
|λI - A| = 0
|λA - I| = 0
|A - I| = 0

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only

⇒ A reflex klystron oscillator uses
one cavity resonator
two cavity resonators
three cavity resonators
none of the above

⇒ In FM, when the bandwidth is doubled, the signal to noise ratio improves by a factor of
2 dB
4 dB
6 dB
8 dB

⇒ For full wave rectification four diode bridge rectifier is claimed to have following advantages:

Less expensive transformer
Small size transformer
Suitable for higher voltage applications

Which of these are correct?
1 and 2 only
1 and 3 only
2 and 2 only
1, 2, 3

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒ The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about
1200 Ω
120 Ω
600 Ω
10 Ω

⇒ Which of the following oscillator is not in FM?
Crystal oscillator
Hartley oscillator
Colpitts oscillator
All of the above

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point

⇒ Which of the following is a valid real variable in FORTRAN 77?
IT
GURGAON
42892
SUNDAY

⇒

Assertion (A): The duty cycle of a class C amplifier affects the power dissipation of transistor

Reason (R): At higher harmonics the efficiency of a class C amplifier becomes poor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE₁₀ mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be
31.11 mW
31.11 W
31.11 kW
31.11 MW