Question is ⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are, Options are ⇒ (A) electrons, drift, (B) holes, drift, (C) holes, diffusion, (D) electrons, diffusion, (E) , Leave your comments or Download question paper.

Question is ⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are, Options are ⇒ (A) electrons, drift, (B) holes, drift, (C) holes, diffusion, (D) electrons, diffusion, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
A.	electrons, drift [Wrong Answer]
B.	holes, drift [Wrong Answer]
C.	holes, diffusion [Correct Answer]
D.	electrons, diffusion [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The simplest method of suppression of unwanted side band in AM is
filter method
phase shift method
third method
both (a) and (b)

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ An MTI compares a set of received echos with those received during the previous sweep.
TRUE
FALSE

⇒ For a = - 1, find the value of V_{2∞
0
V₁
none of the above}

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ As the reverse voltage is increased, the depletion layer
becomes narrow
widens
remains the same
reduce to zero

⇒

Assertion (A): SSB systems generally have duplex operation

Reason (R): SSB systems are generally used in two way communication.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure, V_{0zero
5.7 V
6.9 V
12.6 V}

⇒ Negative feedback reduces noise originating at the amplifier input.
TRUE
FALSE

⇒ 71₈ = __________ .
111000₂
111001₂
100001₂
110001₂

⇒ The baud rate is
not equal to signalling rate
always equal to bit transfer rate
equal to twice the bandwidth of an ideal channel
equal to half the bandwidth of ideal channel

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is
a larger floating point number
a smaller floating point number
either (a) or (b) depending on the actual number
a negative floating point number

⇒ (100101)₂ is
(37)₁₀
(69)₁₀
(41)₁₀
(5)₁₀

⇒ In dielectric heating, the thyristor circuits consist of
rectifier-chopper combination
controlled rectifier
ac regulator
rectifier-inverter combination

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ An electric charge Q is placed in a dielectric medium which of the following quantities are independent of the dielectric constant ε of the medium
electric potential V and electric field intensity E
displacement density D and displacement φ
electric field intensity E and displacement φ
electric potential V and displacement φ

⇒ The disadvantage of FM over AM is that
high output power is needed
high modulating power is needed
noise is very high for high frequency
large bandwidth is required

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p

⇒

Match the following:

	List I (Octal)		List II (Hexadecimal)
A.	66	1.	3 F
B.	77	2.	36
C.	55	3.	27
D.	47	4.	3D

A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-2, D-4
A-4, B-1, C-2, D-3

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Which one of following is a stataic system?
y(n) = x(n) - x(n - 1)
y(n) = x(2n) - x(2n-1)
y(n) = x(n - 1)
y(n) = e^x(n)

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒ In AM, if modulation index is more than 100%, then
bandwidth increases
the wave gets distorted
power of the wave increases
efficiency of transmission increases

⇒ Pico-farad is equal to
10^-6 farad
10^-12 farad
10^-3 farad
10^-9 farad

⇒ The concentration of minority carriers in an extrinsic semiconductor under equilibrium is
directly proportional to the doping concentration
inversely proportional to doping concentration
directly proportional to intrinsic concentration
inversely proportional to the intrinsic concentration