Question is ⇒ A transistor amplifier is operating in class A mode. If a transformer is connected for impedance matching, the efficiency will, Options are ⇒ (A) increase, (B) decrease, (C) not be affected, (D) increase or decrease, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor amplifier is operating in class A mode. If a transformer is connected for impedance matching, the efficiency will, Options are ⇒ (A) increase, (B) decrease, (C) not be affected, (D) increase or decrease, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor amplifier is operating in class A mode. If a transformer is connected for impedance matching, the efficiency will
A.	increase [Correct Answer]
B.	decrease [Wrong Answer]
C.	not be affected [Wrong Answer]
D.	increase or decrease [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ A 0-200 V voltmeter has an accuracy of 0.75% of full scale reading. If voltage measured is 100 V, the error is
0.03
0.02
0.015
0.0075

⇒ To measure a resistance of about 8 ohms we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (b) or (c)

⇒ A hexadecimal odometer displays F52F. The next reading will be
E 52 F
E 52 E
E 53 F
F 53 O

⇒ In a series operated thyristor configuration, each thyristor should support 100 V. However, the three thyristors only support voltage of 100 V, 90 V and 85 V respectively. Hence, the string efficiency in the case is :
0.9845
0.4584
0.9167
none of these

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ The Boolean function A + BC is reduced form of
AB + BC
AB + ABC
(A + B) (A + C)
(A + C)B

⇒ For a standard 2nd order system the maximum overshoot is 10% to an unit step input. If the magnitude of the input is doubled, then maximum overshoot and percentage of maximum overshoot is:
maximum overshoot doubles and percentage of maximum overshoot is less than double
maximum overshoot doubles and percentage of maximum overshoot do not change
maximum overshoot remain same and percentage of maximum overshoot is double
maximum overshoot more than double and percentage of maximum overshoot is less than double

⇒ Electric dipole moment is usually expressed in debye units. Here, 1 debye unit equals
3.33 x 10^-30 C-m
3.33 x 10^-30 C-m²
3.30 x 10^-10 C-m
3.33 x 10^-10 C-m²

⇒

Assertion (A): In Figure, the intercept of the line on y-axis is equal to N (a_e + a_i), where N is number of atoms/m³, a_e is electronic polarizability and a_i is ionic polarizability.

Reason (R): a_e and a_i are independent of temperatu
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Y signal has maximum percentage of
red colour
blue colour
green colour
red and blue colours

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ A 3 phase ac regulator uses
3 thyristors
6 thyristors
9 thyristors
12 thyristors

⇒ The most widely used diode rectifier circuit is
half wave
full wave with centre tapped transformer
bridge
either (a) or (b)

⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^-t. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^-t
2 sin (t + 45°) + e^-t
sin (t - 45°) + e^-t
sin (t + 45°) + e^-t

⇒ The instruction MOV M, r in 8085
causes content of register r to be moved to memory location whose address is in register H, L and uses register indirect addressing mode
causes the content of memory location whose address is in register H, L to move to register r and uses register indirect addressing mode
causes the content of register r to be moved to memory location whose address is in register H, L and uses immediate addressing mode
causes the content of memory location whose address is in register H, L to move to register r and uses immediate addressing mode

⇒ During discharging a capacitor through a resistance, voltages across R and C are equal in magnitude.
TRUE
FALSE

⇒ A linear discrete time system has the char. equation z³ - 0.81z = 0, the system is
stable
marginally stable
unstable
stability cannot be assessed from the given information

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the direction of current
antiparallel to magnetic field
in arbitrary direction

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be
50 Hz
100 Hz
200 Hz
400 Hz

⇒ Which of the following exhibits negative resistance in a portion of its characteristics?
Tunnel diode
Zener diode
JFET
MOSFET and tunnel diode

⇒ In 8085 microprocessor, what is the length of IR (instruction register)?
6 bits
8 bits
12 bits
16 bits

⇒

Assertion (A): Light triggering is very suitable for HVDC transmission.

Reason (R): Light triggering has the advantage of complete electrical isolation of gate circuit.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In metals, the average drift velocity of electron per unit field is called mobility.
TRUE
FALSE

⇒ The power dissipated per gate
is constant at all frequencies
increases with frequency
decreases with frequency
may increase or decrease with frequency

⇒ As EM waves travel in free space they get
reflected
refracted
attenuated
absorbed

⇒ Shift left and shift right operations occur in a calculator.
TRUE
FALSE

⇒ In TV broadcast, UHF range is
606 - 790 MHz
100 - 150 MHz
41 - 68 MHz
174 - 230 MHz