Question is ⇒ A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is, Options are ⇒ (A) 300 mW, (B) 330 mW, (C) 350 mW, (D) 380 mW, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is, Options are ⇒ (A) 300 mW, (B) 330 mW, (C) 350 mW, (D) 380 mW, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is
A.	300 mW [Wrong Answer]
B.	330 mW [Wrong Answer]
C.	350 mW [Correct Answer]
D.	380 mW [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statements

Impedance of Gunn diode is about tens of ohms.
Impedance of Impatt diode is a few ohms.
Impedance of Impatt diode are of the same order.
Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?
all
1 and 2 only
1, 2 and 3
1, 2 and 4

⇒ Two discrete time systems with impulse responses h₁[n] = δ[n - 1] and h₂[n] = δ[n - 2] are connected in cascade. The overall impulse response of the cascaded system is
δ[n - 1] + δ[n - 2]
δ[n - 4]
δ[n - 3]
δ[n - 1] + δ[n - 2]

⇒ The dc voltage on plate modulated class C amplifier is 8 kV. If the peak modulating voltage is 4 kV, the peak RF voltage delivered to load is
32 kV
12 kV
0.5 kV
24 kV

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with e_r = 15. The reflection coefficient for normal incidence is
0.6 ∠0°
1 ∠0°
0.6 ∠180°
1.2 ∠180°

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ Which one of following is a stataic system?
y(n) = x(n) - x(n - 1)
y(n) = x(2n) - x(2n-1)
y(n) = x(n - 1)
y(n) = e^x(n)

⇒ In a digital circuit, a clock is a
crystal type
multivibrator
flip-flop
free running multivibrator

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ To determine the polarity of voltage drop across a resistor, it is sufficient to know
direction of current through the resistor
direction and magnitude of current through the resistor
direction and magnitude of current and value of resistance
magnitude of current through the resistance

⇒ If ROC of x[n] is R₁ then ROC of aⁿ x[n] is
R₁a
R₁/a
a/R₁
R₁ + a

⇒ In rectifiers the use of RC filters is recommended when
load current is high
load current is small
load current is neither high nor small
either (a) or (c)

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ In the following non-planar graph no.of independent loop equations
8
12
7
5

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping

⇒ In figure as the load resistance is cha
the zener current remain constant
the load current remains constant
the output voltage remains constant
the output voltage and current through R remain constant

⇒ An electromagnetic wave incidents on a perfect insulator at an angle. If the wave is not entirely parallel polarized, then
the reflected wave will be entirely polarized parallel to the plane of incidence
there will be no reflection
the reflected wave will be entirely polarized perpendicular to the plane of incidence
any of the above

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒ The characteristic impedance of a cable is about
300 Ω
50 Ω
5 Ω
2 Ω

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ Microprocessors were introduced in the year
1951
1961
1971
1981

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ For the system in the given figure, the transfer function C(s)/R(s
G₁ + G₂ + G₃
G₁ G₂ + G₃
G₁ G₂ G₃
(G₁ + G₂) G₃

⇒

Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The inputs A, B, C of the given figure are applied to a 3 input NOR gate. The outpu
HIGH from 4 to 0
LOW from 0 to 4
HIGH from 0 to 1 and LOW from 1 to 4
LOW from 0 to 2 and HIGH from 2 to 4

⇒ The integral of a unit impulse is
a unit step function
a ramp function of slope 1
a pulse function of magnitude 1
none of the above

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k10¹⁰
10⁷
1.414 x 10^-10
2 x 10^-20

⇒
Match the following:
List I (I/P - O/P relation) List II (Property of the system)
A. y(n) = x(n) 1. Nonlinear, non-causal
B. y(n) = x(n²) 2. Linear, non casual
C. y(n) = x²(-n) 3. Linear causal
D. y(n) = x²(n) 4. Nonlinear causal

A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4
A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2

	List I (I/P - O/P relation)		List II (Property of the system)
A.	y(n) = x(n)	1.	Nonlinear, non-causal
B.	y(n) = x(n²)	2.	Linear, non casual
C.	y(n) = x²(-n)	3.	Linear causal
D.	y(n) = x²(n)	4.	Nonlinear causal

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math