Question is ⇒ A variable resistance R and capacitive reactance X<sub>C</sub> are connected in series. As R is varied, the locus of Z is, Options are ⇒ (A) a straight line parallel to Y axis in 4th quadrant, (B) a straight line parallel to X axis in 4th quadrant, (C) a straight line parallel to Y axis in second quadrant, (D) a straight line parallel to Y axis in first quadrant, (E) , Leave your comments or Download question paper.

Question is ⇒ A variable resistance R and capacitive reactance X<sub>C</sub> are connected in series. As R is varied, the locus of Z is, Options are ⇒ (A) a straight line parallel to Y axis in 4th quadrant, (B) a straight line parallel to X axis in 4th quadrant, (C) a straight line parallel to Y axis in second quadrant, (D) a straight line parallel to Y axis in first quadrant, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
A.	a straight line parallel to Y axis in 4th quadrant [Wrong Answer]
B.	a straight line parallel to X axis in 4th quadrant [Wrong Answer]
C.	a straight line parallel to Y axis in second quadrant [Correct Answer]
D.	a straight line parallel to Y axis in first quadrant [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The depth of penetration at 4 MHz is 10 cm, then at 2.5 MHz it is
62.5 cm
13 cm
6.25 cm
8 cm

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
y + 0.57x = 9.7558
y - 0.57x = 9.758
033y + x = 6.335
0.33y - x = 6.335

⇒ Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is
TTL
CMOS
ECL
TTLLS

⇒ In spread spectrum technique
a modulated signal is modulated again
a modulated signal is modulated twice again
the power of a modulated signal is increased
the noise component of a modulated signal is decreased

⇒ In a microprocessor
one machine cycle is equal to one clock cycle
one clock cycle consists of several machine cycles
one machine cycle consists of several clock cycles
one machine cycle is always less than one clock cycle

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ In a p type material the Fermi level is 0.3 eV above valence band. The concentration of acceptor atoms is increased. The new position of Fermi level is likely to be
0.5 eV above valence band
0.28 eV above valence band
0.1 eV above valence band
below the valence band

⇒ The op amp is used in
A/D converters
D/A converters
both (a) and (b)
shift registers

⇒

Assertion (A): The hybrid p model of a transistor can be reduced to h parameter model and vice versa.

Reason (R): Hybrid p and h parameter models are interrelated as both of them describe the same device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following contributes to harmonics distortion in amplifiers?
Positive feedback
Presence of noise
Defective active device
Non-linearity in active device

⇒ Which of the following statements is not true in regard to storage time of a diode?
During this time, the diode is reverse-biased
The diode conducts during this time
It is due to the time taken by carriers to depart from the function when the diode is reverse-biased
During this time the diode current is zero

⇒ In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ Loss of charge method is suitable for medium resistances.
TRUE
FALSE

⇒ A bridge type single phase cycloconverter changes the frequency f to f/3. Then one half wave of output contains
3 full waves of input
3 half waves of input
6 full waves of input
6 half waves of input

⇒ The range of signed decimal number that can be represented by 6 bit in complement number is
-31 to +31
-63 to +64
-64 to +63
-32 to +31

⇒ Two similar mutually coupled coils have a total inductance of 900 mH and coefficient of coupling 0.5. The self inductance of each coils is
300 mH
150 mH
75 mH
50 mH

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ If the open-loop transfer function is a ratio of a numerator polynomial of degree 'm' and a denominator polynomial of degree 'n', then the integer (n - m) represents the number of:
breakaway points
unstable poles
separate root loci
asymptotes

⇒ Audio-signal modulates a 125 MHz carrier, causing a frequency deviation of 5 kHz. The bandwidth of the narrowband FM signal is __________ kHz.
10
8
9
20

⇒ For a base current of 10 μA, what is the value of collector current in common emitter if β_dc = 100
10 μA
100 μA
1 mA
10 mA

⇒ The lowest frequency used in satellite communications is __________ GHz.
0.8
3
18
30

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ __________ switch, a T flip-flop is used as __________ switch, a T flip-flop is used as switch
toggled, delay
delay, toggle
set reset
reset, set

⇒ Two infinitely long wires carrying current are as shown in the figure below. One wire is in the y-z plane and parallel to the y-axis. The other wise is in the x-y plane and parallel to the x-axis. Which components of the resulting magnetic field are non-zero at the ori
x, y, z components
x, y components
y, z components
x, z components

⇒ Principle of superposition is applicable to
linear systems only
nonlinear systems only
both linear and non linear system
linear systems and some nonlinear systems

⇒ For the system of the given figure, the closed loop poles ar
0 and -4
-2 ± j6
2 ± j6
-3 ± j8

⇒ Spontaneous polarization occurs in ferroelectric materials.
TRUE
FALSE

⇒ The ripple factor of a full wave rectifier is about 0.5
TRUE
FALSE

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp