Question is ⇒ In a certain network not containing any dependent sources, number of nodes = 4 and number of branches is equal to 6., Options are ⇒ (A) 4, (B) 2, (C) 3, (D) 5, (E) , Leave your comments or Download question paper.

Question is ⇒ In a certain network not containing any dependent sources, number of nodes = 4 and number of branches is equal to 6., Options are ⇒ (A) 4, (B) 2, (C) 3, (D) 5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a certain network not containing any dependent sources, number of nodes = 4 and number of branches is equal to 6.
A.	4 [Wrong Answer]
B.	2 [Wrong Answer]
C.	3 [Correct Answer]
D.	5 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a two phasor servomotor, the direction of rotation of the rotating field depends on
magnitudes of voltages applied to the two stator windings
phase relation of voltages applied to the two stator windings
both magnitude and phase relationship of voltages applied to the two stator windings
none of the above

⇒ For a transistor to have-a larger β it must have and a
close to zero
close to 0.5
close to unity
nearly infinite

⇒ In CB amplifier the distortion of the input voltage waveform may occur due to
very low input resistance of an amplifier
very high input resistance of the amplifier
improper biasing
ripples in power supply

⇒ The colour code on a carbon resistor is green-blue-yellow. The tolerance is
± 5%
± 10%
± 20%
± 30%

⇒ In n type semiconductor, the free electron concentration
is nearly equal to density of donor atoms
is much greater than density of donor atoms
is much less than density of donor atoms
may be equal to or more or less than density of donor atoms

⇒ Consider the following:

Coupling capacitor
Emitter by-pass capacitor
Emitter to base diffusion capacitance of the BJT
Stray capacitance of the circuit.

Which of these components in a R-C coupled amplifier control the lower cut-off frequency of the amplifier?
1 and 2
2 and 3
3 and 4
l and 4

⇒ In which of the following logical group instructions of 8085 do the contents of accumulator remain unchanged?
ORA r
ORA M
ORI data
CMP r

⇒ Assuming V_{CE sat} = 0.2 V and β = 50, the minimum base current (I_B) required to drive the transistor in the given figure to saturatio
56 μA
140 μA
60 μA
3 μA

⇒ In the above circuit, if the power dissipated in the 6 Ω resistor is zero then
20 2∠ 45°
20 ∠ 30°
20 ∠ 45°
20 2∠ 30°

⇒ A capacitor whose capacitance C_t = C₀ (1- cos ωt) is fed by a sinusoidal voltage v = V₀ sin ωt. The equation for current i is
ω C₀V₀ cos ωt
ω C₀V₀ sin ωt
ω C₀V₀ (cos ωt - cos² ωt)
none of the above

⇒ A class B chopper operates in third quadrant.
TRUE
FALSE

⇒ The passage of current in an electrolyte is due to the movement of
electrons
molecules
atoms
ions

⇒ The spectral range of a band pass signal extends from 10 MHz to 10.4 MHz. What is the minimum sampling frequency required for reconstruction?
20 MHz
20.8 MHz
20.4 MHz
0.8 MHz

⇒ What is the characteristic of a good control system?
Sensitive to parameter variation
Insensitive to input command
Neither sensitive to parameter variation nor sensitive to input commands
Insensitive to parameter variation but sensitive to input commands

⇒ Which of these has peak and valley points in v-i curve?
Tunnel diode
Zener diode
PIN diode
Schottky diode

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒

Hall coefficient R_H is directly proportional to the charge density
R_H depends upon type of the semiconductor material (n - type or p - type)
Hall co-efficient R_H is directly proportional to hall voltage V_H

From the above statements which are the false statements?
I only
II only
III only
all of the above

⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
15.58 x 10⁶
15.58 kHz
1.58 x 10³
None of the above

⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°

⇒ Out of the following memory types, one that is volatile is
ferrite-core
semiconductor RAM
semiconductor ROM
magnetic disc

⇒ The term efficacy, is defined by
same as efficiency
measure of the ability of a device to produce a desired effect
input/output
(efficiency)²

⇒ I = dq/dt.
TRUE
FALSE

⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
5 ∠19° A
10 ∠19° A
10 ∠38° A
10 ∠9.5° A

⇒ An ac wave with superimposed dc is symmetrical about x - axis.
TRUE
FALSE

⇒

Assertion (A): L[af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)

Reason (R): Initial value theroem enables us to find the value of f(t) at t = 0 directly from F(s)

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ For most metals, Fermi level E_F is less than
0.1 eV
2 eV
5 eV
10 eV

⇒ The static equalisation circuit for thyristors connected in series is
one resistor in series with each thyristor
one resistor in parallel with each thyristor
one resistor and one capacitor in parallel with each thyristor
none of the above

⇒ In CC configuration, the output signals has approximately
the same amplitude and phase
opposite amplitude and phase
same amplitude but opposite phase
none of the above