Question is ⇒ Which quantity controls the effectiveness of LED in emitting light?, Options are ⇒ (A) Applied voltage, (B) Current, (C) Extent of doping, (D) Temperature, (E) , Leave your comments or Download question paper.

Question is ⇒ Which quantity controls the effectiveness of LED in emitting light?, Options are ⇒ (A) Applied voltage, (B) Current, (C) Extent of doping, (D) Temperature, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which quantity controls the effectiveness of LED in emitting light?
A.	Applied voltage [Wrong Answer]
B.	Current [Wrong Answer]
C.	Extent of doping [Wrong Answer]
D.	Temperature [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The spectrum of the white noise and an impulse function is similar in following aspects
both have similar magnitude spectrum
both have similar magnitude and Phase spectrum
no relation
similar phase spectrum

⇒ In radar PRF depends on maximum range.
TRUE
FALSE

⇒ A microprocessor needs memory chips and input-output chip to form a microcomputer.
TRUE
FALSE

⇒ Gain of isotropic antenna is
10 dB
0 dB
∞
1 dB

⇒ The clear data and present input of the JK flip-flop are known as
direct inputs
synchronous inputs
indirect inputs
either direct inputs or synchronous inputs

⇒ In Bode method of stability analysis, the error curve is not symmetric about corner frequency.
TRUE
FALSE

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ Induction wattmeter can be used in
ac circuit only
dc circuit only
both ac and dc circuit
ac 3 phase only

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ Which of the following expressions is true for apparent power in an A.C. circuit?
VI cos Φ
V_av x I_av
V_r.m.s x I_r.m.s
V_peak x I_peak

⇒ When a complex signals is used to frequency modulate a carrier, the resulting sideband distribution is
symmetrical about the carrier
not necessarily symmetrical about the carrier
decided by the predominant sidebands
none of the above

⇒

Assertion (A): Cut-in voltage for Germanium diode is greater than that for silicon diode.

Reason (R): Germanium diode has a higher reverse saturation current than silicon diode.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a vibrating reed frequency meter the natural frequency of two adjacent reeds have a difference of
0.25 Hz
0.5 Hz
1.25 Hz
1 Hz

⇒ Consider the following stateme
1 only
1 and 2
2 and 3
3 only

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒

Assertion (A): In a series resonant circuit current is maximum at resonance.

Reason (R): The inductive and capacitive reactances are equal.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
910 mA
5 mA
5.25 mA
4.95 mA

⇒ A voltage DAC is generally slower than current DAC
because of more accuracy
because of higher resolution
because of response time of op-amp current to voltage converter
none of the above

⇒ MOS circuits as compared to bipolar circuits take
more chip area
less chip area
same chip area
none of these

⇒ For a high pass filter attenuation = 0 at f = 0.
TRUE
FALSE

⇒ A 0.5 μF capacitor is connected across a 10 V battery. After a long time, the circuit current and voltage across capacitor will be
0.5 A and 0 V
0 A and 10 V
20 A and 5 V
0.05 A and 5 V

⇒ A geosynchronous satellite
has the same period a that of the Earth
has a circular orbit
rotates in the equatorial plane
has all of the above

⇒ Covalent bond energy in Germanium is approximately
3.8 eV
4.7 eV
7.4 eV
12.5 eV

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get
zero power
∞ power
depend upon input signal strength
depend on frequency

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM

⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V

⇒ In a computer the instructions, data, intermediate and final results during processing are held in ALU.
TRUE
FALSE

⇒ Costa's receiver is used for
coherent detection of AM-SC signal
asynchronous detection of AM-SC signal
amplitude modulation of signal
frequency modulation of signal