Question is ⇒ A compiler is a software programme which, Options are ⇒ (A) change high level Programming language into low level machine language, (B) change the program into binary form, (C) assembles the program, (D) executes the program, (E) , Leave your comments or Download question paper.

Question is ⇒ A compiler is a software programme which, Options are ⇒ (A) change high level Programming language into low level machine language, (B) change the program into binary form, (C) assembles the program, (D) executes the program, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A compiler is a software programme which
A.	change high level Programming language into low level machine language [Correct Answer]
B.	change the program into binary form [Wrong Answer]
C.	assembles the program [Wrong Answer]
D.	executes the program [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a Vidicon camera tube, the beam current is controlled by
grid G₁
grid G₂
grids G₁, G₂, G₃
grid G₂, G₃

⇒ The main advantage of superheterodyne receiver is
better tracking
simple cut
better alignment
improvement in selectivity and sensitivity

⇒ In case of a transistor amplifier the emitter resistance R_e is removed
the gain of the amplifier will reduce
heat sink will not be required
Q-point will become unstable
base to emitter function will be less forward biased

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ The instruction LDA 20 in 8085 means
contents of memory location 20 are fetched into the accumulator
the value 20 is fetched into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ Which inverter circuit uses coupled inductors?
Modified McMurray full bridge inverter
McMurray Bedford half bridge inverter
Modified McMurray Bedford half bridge inverter
Both (b) and (c)

⇒ Which of the following features is not associated with Nichols chart?
(0 dB, -180°) point on Nichols chart represent critical Point (-1, 0)
It is symmetric about -180°
M loci are centred about (0 dB, -180°) point
The frequency at intersection of G(jω) locus and M = +3 dB locus gives bandwidth of closed loop system

⇒ In setting up 'for' loops in Pascal, the initial and final values of index may be
integer constants
Integer constants or integer variable names
integer constants or integer variable names or integer expressions
integer constants or real constants

⇒ The operator precedence in Java is in the order
arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.
increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.
comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.
arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ In a micro computer the control bus
transmits and receives control signals between processor and other devices
transmits and receives control signals, also sends and receives data
transmits and receives control signals, sends and receives data and transmits address of the device
none of the above

⇒ In 8086 the number of lines on which data and address is multiplexed is
8
16
20
32

⇒ The effective channel length of a MOSFET in saturation decreases with increase in
gate voltage
drain voltage
source voltage
body voltage

⇒ A conductor is said to be perfect if it has __________ conductivity
finite
infinite
unity
zero

⇒ In colour TV system the colour sub carrier frequency is 4.43 MHz.
TRUE
FALSE

⇒ 'Rotate instruction' in microprocessor belongs to
data transfer group
arithmetic group
logic group
branch group

⇒ High cut off frequency can be expected in case of
common-base
common-emitter
common-collector
all of the above

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒

Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about g_m r_d

Reason (R): A common source amplifier is a source follower circuit

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Loading of a line means
increasing inductance of line
increasing distributed inductance of line
decreasing distributed inductance of line
decreasing inductance of line

⇒ A 7477 decoder drives
seven-segment display
nickel tape
relays
diode matrix

⇒ In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?
TE₀₁
TE₁₁
TE₀₅
TE₂₁

⇒ The maximum rectification efficiency in case of full wave rectifier is
1
0.812
0.666
0.406

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage

⇒

Assertion (A): A decrease in temperature increases the reverse saturation current in a p-n diode.

Reason (R): When a diode is reverse biased surface leakage current flows.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A circular waveguide has an infinite set of TE and TM modes.
TRUE
FALSE

⇒ The current in a circuit is measured using a 150 : 1 CT If the ammeter reads 0.6 A, the circuit current is
250 A
90 A
156 A
144 A

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒

Assertion (A): In a conductor, current density remains constant in time as long as E is constant.

Reason (R): In a conductor, J = σE.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true