Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
The input to negative clamper has a peak value of V_{p}. Then in the output the positive and negative peaks are nearly | |
A. | 0 and -2 V respectively [Correct Answer] |
B. | V_{p} and -V_{p} respectively [Wrong Answer] |
C. | 2 V_{p} and 0 respectively [Wrong Answer] |
D. | none of the above [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ If V_{in} is 0.99 V, what is the digital output of the ADC 0801 after INTER goes low?
0011 0011
0101 1111
0111 1100
1111 1111
⇒ In the circuit shown in the given figure, power dissipated in the 5 Ω resisto
zero
80 W
125 W
405 W
⇒ 2's complement of a given 3 or more bit number of non-zero magnitude is the same as the original number if all bits except
MSB are zero
LSB are zero
MSB are 1
LSB are 1
⇒ Padders are used in a receiver to
discard the carrier
facilitate tracking
filter the input signal
suppress noise
⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_{m} is equal to
2f_{c}
f_{c}
0.5 f_{c}
3 f_{c}
⇒ Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes
⇒ If V_{A} = - 10 V and V_{B} = - 15 V, VAB = 5 V.
TRUE
FALSE
⇒ A multivibrator generates
sinusoidal waveforms
non-sinusoidal waveforms
both (a) and (b)
none of the above
⇒ In an RC phase shift oscillator, the total phase shift of the three RC lead networks is
360°
180°
90°
0°
⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true
⇒ In the circuit shown in the given figure, R_{L} will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω
⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization
⇒ The law J = σE, where J is current density, σ is electrical conductivity and E is field strength is
Ohm's law
Gauss law
Ampere's law
Biot-Savart law
⇒ In selecting a satellite system, the First determining factor is its
EIRP
antenna size
coverage a sea
antenna gain
⇒ The subtraction of a binary number Y from another binary number X, done by adding the 2's complement of Y to X results in a binary number without overflow. This implies that the result is
-ve and is in normal form
-ve and 2's complement form
+ve and is in normal form
+ve and in 2's complement
⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic
⇒ Consider the following statements.
2, 4, 3, 1
2, 4, 1, 3
4, 2, 1, 3
3, 2, 3, 1
⇒ The radiation pattern of Hertzian dipole in the plane perpendicular to dipole is a
null
circle
figure of eight
none of the above
⇒ For Bode plot of (1 + jωT) has
slope of 20 dB/decade and phase angle + tan^{-1} (ωT)
slope of - 20 dB/decade and phase angle + tan^{-1} (ωT)
slope of 20 dB/decade and phase angle - tan^{-1} (ωT)
slope of - 40 dB/decade and phase angle - tan^{-1}(ωT)
⇒ The following switching functions are to be implemented using a decoder
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line
⇒ In Laplace transform, multiplication by e^{-at} in time domain becomes
translation by a in s domain
translation by (-a) in s domain
multiplication by e^{-as} in s domain
none of the above
⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
resistor R_{1}
condenser C_{2}
condenser C_{1}
inductor L
⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above
⇒ In an amplifier circuit the emitter is at ac ground potential in a
CB circuit
CC circuit
CE circuit
both CB and CE circuit
⇒ A static induction thyristor
is a majority carrier device
is a minority carrier device
either a majority carrier or minority carrier device
has a total number of 2 leads
⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively
⇒
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true
⇒ A crystal is frequently used in digital circuits for timing purpose because of its
low cost
high frequency stability
simple circuitry
ability to set frequency at desired value
⇒ Which of the following lines is non-radiating?
Open two wire
Coaxial
Both
None of the above
⇒ If V_{in} is 0.99 V, what is the digital output of the ADC 0801 after INTER goes low?
0011 0011
0101 1111
0111 1100
1111 1111
⇒ In the circuit shown in the given figure, power dissipated in the 5 Ω resisto
zero
80 W
125 W
405 W
⇒ 2's complement of a given 3 or more bit number of non-zero magnitude is the same as the original number if all bits except
MSB are zero
LSB are zero
MSB are 1
LSB are 1
⇒ Padders are used in a receiver to
discard the carrier
facilitate tracking
filter the input signal
suppress noise
⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_{m} is equal to
2f_{c}
f_{c}
0.5 f_{c}
3 f_{c}
⇒ Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes
⇒ If V_{A} = - 10 V and V_{B} = - 15 V, VAB = 5 V.
TRUE
FALSE
⇒ A multivibrator generates
sinusoidal waveforms
non-sinusoidal waveforms
both (a) and (b)
none of the above
⇒ In an RC phase shift oscillator, the total phase shift of the three RC lead networks is
360°
180°
90°
0°
⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms
⇒
Assertion (A): A 4 input variable logic circuit can be implemented using a 8 : 1 multiplexer.
Reason (R): When a multiplexer is used as a logic function generator, the logic design is simple.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true
⇒ In the circuit shown in the given figure, R_{L} will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω
⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization
⇒ The law J = σE, where J is current density, σ is electrical conductivity and E is field strength is
Ohm's law
Gauss law
Ampere's law
Biot-Savart law
⇒ In selecting a satellite system, the First determining factor is its
EIRP
antenna size
coverage a sea
antenna gain
⇒ The subtraction of a binary number Y from another binary number X, done by adding the 2's complement of Y to X results in a binary number without overflow. This implies that the result is
-ve and is in normal form
-ve and 2's complement form
+ve and is in normal form
+ve and in 2's complement
⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic
⇒ Consider the following statements.
- Etching
- Exposure to UV radiation
- Stripping
- Developing
2, 4, 3, 1
2, 4, 1, 3
4, 2, 1, 3
3, 2, 3, 1
⇒ The radiation pattern of Hertzian dipole in the plane perpendicular to dipole is a
null
circle
figure of eight
none of the above
⇒ For Bode plot of (1 + jωT) has
slope of 20 dB/decade and phase angle + tan^{-1} (ωT)
slope of - 20 dB/decade and phase angle + tan^{-1} (ωT)
slope of 20 dB/decade and phase angle - tan^{-1} (ωT)
slope of - 40 dB/decade and phase angle - tan^{-1}(ωT)
⇒ The following switching functions are to be implemented using a decoder
- f_{1} = ∑m (1, 2, 4, 8, 10, 14)
- f_{2} = ∑m (2, 5, 9, 15)
- f_{3} = ∑m (2, 4, 5, 6, 7)
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line
⇒ In Laplace transform, multiplication by e^{-at} in time domain becomes
translation by a in s domain
translation by (-a) in s domain
multiplication by e^{-as} in s domain
none of the above
⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
resistor R_{1}
condenser C_{2}
condenser C_{1}
inductor L
⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above
⇒ In an amplifier circuit the emitter is at ac ground potential in a
CB circuit
CC circuit
CE circuit
both CB and CE circuit
⇒ A static induction thyristor
is a majority carrier device
is a minority carrier device
either a majority carrier or minority carrier device
has a total number of 2 leads
⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively
⇒
Assertion (A): Ferrites are very useful at very high frequencies.
Reason (R): Ferrites have high permeability and high resistivity.
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true
⇒ A crystal is frequently used in digital circuits for timing purpose because of its
low cost
high frequency stability
simple circuitry
ability to set frequency at desired value
⇒ Which of the following lines is non-radiating?
Open two wire
Coaxial
Both
None of the above