Question is ⇒ For addition and subtraction operations, phasors, Options are ⇒ (A) must be represented in polar form, (B) must be represented in rectangular form, (C) may be represented in any form, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For addition and subtraction operations, phasors, Options are ⇒ (A) must be represented in polar form, (B) must be represented in rectangular form, (C) may be represented in any form, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For addition and subtraction operations, phasors
A.	must be represented in polar form [Wrong Answer]
B.	must be represented in rectangular form [Correct Answer]
C.	may be represented in any form [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒

Assertion (A): A sine wave with slew rate distortion looks rectangular

Reason (R): The maximum rate of output voltage change is called slew rate

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Wagner earthing device eliminates
all stray capacitance in the circuit
stray capacitances between components
stray capacitance between detector terminal and ground
mutual coupling between components

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
13 mm
1.3 mm
130 mm
none of the above

⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other

⇒

Match the following:

	List I		List II
A.	PMMC	1.	Square law type scale
B.	Moving iron	2.	Very good response
C.	Thermo-couple	3.	Linear scale
D.	Electrostatic	4.	Voltmeter

A-4, B-1, C-2, D-3
A-3, B-2, C-1, D-4
A-4, B-2, C-1, D-3
A-3, B-1, C-2, D-4

⇒ Hall effect is observed in a specimen (metal or semi- conductor) when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the same direction as current
in a direction anti parallel to magnetic field
none of the above

⇒ The problem associated with tuned-radio frequency receiver is
instability
insufficient adjacent frequency rejection
bandwidth variation
all of the above

⇒ In a radio receiver, if the intermediate frequency is too high
Selectivity will be poor
Tracking difficulties will be least
Adjacent channel rejection will improve
All of the above will occur

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒ The usable bandwidth of ridge wave guide
is lower than that of rectangular waveguide
is higher than that of rectangular waveguide
is almost same as that of rectangular waveguide
is very small as compared to that of rectangular waveguide

⇒ A 50 p characteristic impedance line is connected to a load which shows a reflection coefficients of 0.268. If V_in = 15 volt, then the net power delivered to the load will be
0.139 W
1.39 W
0.278 W
2.78 W

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ At a temperature of 7 K, lead is a superconductor.
TRUE
FALSE

⇒ A buffer amplifier should have
high output impedance and high input impedance
high output impedance and low input impedance
low output impedance an low input impedance
low output impedance and high input impedance

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ In figure the output v(t)
phase modulated signal
amplitude modulated signal
frequency modulated signal
none of the above

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ An increase of reverse voltage decreases the junction capacitance.
TRUE
FALSE

⇒ Which one of the following statements regarding compandor is FALSE?
It compresses the higher-amplitude parts of a signal before modulation and expands them back to normal again after demodulation.
It gives preferential treatment to the weaker parts of the signal
For weaker signals it gives a poor ratio of signal strength to quantizing error
Weaker signals, traverse more quantum steps than they would do otherwise and so quantizing error is reduced.

⇒ The following graph, the number of trees (P) and the number of cut-sets (Q)
P = 2, Q = 2
P = 2, Q = 6
P = 4, Q = 6
P = 4, Q = 10

⇒

Match the following:

	List I		List II
A.	45	1.	10110100
B.	90	2.	11010010
C.	180	3.	01011010
D.	210	4.	00101101
		5.	10101000

A-3, B-4, C-5, D-2
A-4, B-3, C-5, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒

Assertion (A): Two transistors one n-p-n and the other p-n-p are identical in all respects (doping, construction, shape, size). The n-p-n transistor will have better frequency response.

Reason (R): The electron mobility is higher than hole mobility.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the memory chip size is 256 x 1 bits, then the number of chips required to make up 1 kB (1024) bytes of memory is
32
24
12
8

⇒ Vestigial sideband is most commonly used in
radio transmission
television transmission
telephony
all of the above

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒ The memory segment registers in 8086 are denoted by
AS, BS, CS, DS
BS, CS, SS, ES
CS, DS, SS, ES
DS, ES, FS, SS

⇒ Which of these commutation methods uses two leads?
Class A
Class B
Class C
Class D

⇒ The operating voltage of a megger is about
100 V
12 V
6 V
1 V