Question is ⇒ Companding is used, Options are ⇒ (A) to overcome quantising noise in PCM, (B) in PWM receivers to reduce impulse noise, (C) to protect small signals in PCM from quantising noise, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Companding is used, Options are ⇒ (A) to overcome quantising noise in PCM, (B) in PWM receivers to reduce impulse noise, (C) to protect small signals in PCM from quantising noise, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Companding is used
A.	to overcome quantising noise in PCM [Wrong Answer]
B.	in PWM receivers to reduce impulse noise [Correct Answer]
C.	to protect small signals in PCM from quantising noise [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A coil has resistance R and inductance L. At ω = ∞ the phase angle between voltage and current is
0°
180°
45°
90°

⇒ A signal is x + f(t) where x is constant and f(t) is a power signal with zero mean value. The power of the signal is
x²
x² + f²(t)
more than x² + f²(t)
less than x² + f²(t)

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ Which is correct with respect to computer memory?
Only a particular address can have a particular memory
Any address can have any memory
To read a word from computer memory, it is not necessary to specify a location
None of the above

⇒ In a CE amplifier the Q point is very close to cutoff point on the load line. This results in
saturation clipping
cut off clipping
both saturation and cut off clipping
either saturation clipping or cut off clipping

⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low

⇒ As the number of flip flops are increased, the total propagation delay of
ripple counter increases but that of synchronous counter remains the same
both ripple and synchronous counters increase
both ripple and synchronous counters remain the same
ripple counter remains the same but that of synchronous counter increases

⇒ In a superheterodyne broadcast receiver, the frequency of local oscillator is __________ the incoming signal frequency.
higher than
lower than
equal to
not comparable to

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ The noise performance of a square law demodulator of AM signal is
better than that of an envelope detector
better than that of a synchronous detector
identical with that of a synchronous detector
poorer than that of an envelope detector

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite

⇒

Assertion (A): A synchro control transformer has nearly constant impedance across its rotor terminals.

Reason (R): Rotor of a synchro control transformer is cylindrical so as to give uniform flux distribution.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ As per Boolean algebra, inputs can be interchanged in
OR gates
AND gates
both OR and AND gates
none of the above

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ In control systems the word controller includes
error detector and feedback element
feedback element and control elements
error detector and control elements
error detector, control elements and feedback elements

⇒ If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :
DGη = 1
η = DG
D = ηG
D = G/η

⇒ The receiver of a pulsed RADAR can detect signal power in the order of
1 W
0.1 W
10^-5 W
10^-12 W

⇒ Read the following statements about time and space requirements of microprocessors

Space requirement is also known as memory requirement.
Space requirement is expressed in terms of bytes.
Time requirement is expressed in terms of states.
Time requirement is expressed in terms of μ- s.

Which of the above statements are correct?
1, 2 and 3 only
1, 2 and 4 only
2 and 3 only
1 and 4 only

⇒ For the system of the given figure the closed loop poles are locate
s = 0 and s = -2
s = 0, s = -l ± j3
s = -1 ± j3
s = -2 and s = -1 ± j3

⇒ If an inverter is placed at the input to an SR flip-flop, the result is
T flip-flop
D flip-flop
JK flip-flop
BCD decade counter

⇒ An ideal op-amp can amplify dc signals
TRUE
FALSE

⇒ In a wave the electric field lines are vertical. Then the wave is
horizontally polarized
vertically polarized
either (a) or (b)
neither (a) nor (b)

⇒ For the logic circuit of the given figure,
A + BC
BC
AB
AB + C

⇒ Poynting vector is the rate of energy flow having
W/m²
W-m
kWh/s
W/m

⇒ Measurement of hall coefficient enables the determination of
mobility of charge carriers
type of conductivity and concentration of charge carriers
temperature coefficient and concentration of charge carriers
fermi level and forbidden energy gap

⇒ In 8085
RST 6.5 and RST 5.5 are high level sensitive interrupts
RST 6.5 and RST 5.5 are low level sensitive interrupts
RST 5.5 is low level sensitive interrupt but RST 5.5 is high level-sensitive interrupt
RST 5.5 is low level sensitive interrupt but RST 6.5 is high level sensitive interrupt

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ A 6 bit ladder A/D converter has input 101001. The output is (assume 0 = 0 V and 1 = 10 V)
4.23
6.41
5.52
9.23