Question is ⇒ Current in a 2H inductance in 10e-t A. Admittance of the inductor is, Options are ⇒ (A) -0.5 mho, (B) 0.5 mho, (C) 5 mho, (D) 10 mho, (E) , Leave your comments or Download question paper.

Question is ⇒ Current in a 2H inductance in 10e-t A. Admittance of the inductor is, Options are ⇒ (A) -0.5 mho, (B) 0.5 mho, (C) 5 mho, (D) 10 mho, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Current in a 2H inductance in 10e^-t A. Admittance of the inductor is
A.	-0.5 mho [Correct Answer]
B.	0.5 mho [Wrong Answer]
C.	5 mho [Wrong Answer]
D.	10 mho [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒ In voltage amplifiers, the load resistance
should be a small as possible
should be as large as possible
must be equal to output impedance
must be half of output impedance

⇒ Which of the following is not an omnidirectional antenna?
Log periodic
Half-wave dipole
Discone
Marconi

⇒ Which of the following methods does not cause any reduction in instruction length?
Using program counter
Common source and destination address
Implicit source and destination address
Machine language programming

⇒ The most commonly used transistor amplifier circuit is
CB
CC
CE
CE or CC

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒ A silicon controlled switch has :
2 leads
3 leads
4 leads
5 leads

⇒ In a 3 byte instruction of 8085, the first, second and third byte respectively indicate
operation code, low order byte of data/address and high order byte of data / address
low order byte of data / address, high order byte of data / address and operation code
high order byte of data / address, low order byte of data / address and operation code
high order byte of data / address, operation code and low order byte of data / address

⇒ At room temperature the barrier potential in a silicon diode is
0.1 V
0.3 V
0.7 V
1 V

⇒

Match the following:

	List I (Oscillator)		List II (Features)
A.	Wien Bridge	1.	RF oscillator, uses two inductors and one capacitor
B.	Colpitt's	2.	LC oscillator for radio frequencies uses three capacitances and one inductance
C.	Hartley	3.	RC oscillator for audio frequencies
D.	Clapp	4.	RF oscillator, uses two capacitances and one inductance

A-2, B-1, C-4, D-3
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about
330 m/s
334 m/s
353 m/s
380 m/s

⇒ In standard TTL, the 'totem pole' stage refers to
the multi-emitter I/P stage
phase splitter
the O/P buffer
open collector O/P stage

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require
1120 bits
2240 bits
33 bits
64 bits

⇒ In a circuit using a full wave converter (M - 2 connection) the PIV of each thyristor is 400 V. For the same output voltage and fully controlled bridge converter, PIV will be
400 V
800 V
200 V
2002 V

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above

⇒ In the full adder, denoting Sum by S and carry by C
S = 1 when two or more inputs are unity
C = 1 when two or more inputs are unity
C = 1 when all the inputs are unity
S = 1 when all the inputs are unity

⇒ Which of the following are universal gates?

NAND
NOR
XOR

Select the correct answer from the codes given below:
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ A message signal x(t) is amplitude modulated with carrier c(t2ω
3ω
1ω
0.5ω

⇒ Choose the correct option
var (X) = σ_x²
σ² = E(X²) - μ²
var (CX) = C² Var (X)
all

⇒ Which of the following statements is not correct for thermistors?
They have negative temperature coefficient of resistance
The sensing element is made of sintered ceramics, which are oxides of metals in the form of beads
The variation of resistance with temperature is linear
The resistance value at ambient temperature may range from 100 Ω to 100 kΩ

⇒ Microwaves
get reflected by ionosphere
are absorbed by ionosphere
are neither reflected nor absorbed by ionosphere
are both reflected and absorbed by ionosphere

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ A static excitation system uses
transformer and thyristors
transformer and ac exciter
dc exciter and ac exciter
transformer and dc exciter

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ A pulse width signal can be governed by
free running multi-vibrator
monostable multi-vibrator
Schmitt trigger
JK flip-flop

⇒ In a 4 input AND gate, the total number of High outputs for 16 input states are
16
8
4
1

⇒ If A = 0101, then A' is
1010
1011
1001
110

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math