Question is ⇒ Thermistor is used in, Options are ⇒ (A) temperature measurement, (B) temperature control, (C) high temperature alarm circuits of devices, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Thermistor is used in, Options are ⇒ (A) temperature measurement, (B) temperature control, (C) high temperature alarm circuits of devices, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Thermistor is used in
A.	temperature measurement [Wrong Answer]
B.	temperature control [Wrong Answer]
C.	high temperature alarm circuits of devices [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure below shows D type Flip-Flops connected as shift register, then outputs Q_D, Q_C, Q_B, Q_A are given
1 and 2 only
2 and 3 only
1, 2 and 3
none of these

⇒

Assertion (A): If an atom of polarizability a is placed in homogeneous field E, the energy stored is 0.5 aE².

Reason (R): Capacitance of an isolated conducting sphere R in vacuum is 4 p∈₀ R farads.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ Consider the following DO statement in FORTRAN 77 7
6
1
8

⇒ In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition
A_v → ∞
1 << A_v → ∞
A_v ≈ 1
A_v << 1

⇒ In a pure sample of silicon
the number of holes and free electrons is always equal
the number of free electrons is more than the number of holes
the number of free electrons and holes is equal at low temperature
the number of free electrons is less than number of holes

⇒

Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
22000 Ω
2200 Ω
22 ± 5% Ω
22 ± 10% Ω

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ If the variance σ_x² of d(n) = x(n) - x(n - 1) is one-tenth the variance σ_x² of a stationary zero mean discrete time signal x(n), then the normalized autocorrelation function R_xx(x)/σ_x² at k = 1 is
0.95
0.9
0.1
0.05

⇒ Which one of the following is correct?
RAM is a volatile memory but ROM is non-volatile memory
RAM is non-volatile memory but ROM is volatile memory
Both ROM and RAM are volatile but in ROM data is not lost when power is switched off
Both ROM and RAM are non-volatile but in RAM data is lost when power is switched off

⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?
0.375 V
15 V
4.5 V
10 V

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ For the system of the given figure, the undamped natural frequency of closed loop pole
2 rad/sec
1 rad/sec
0.5 rad/sec
0.25 rad/sec

⇒ The ground waves eventually disappear as one moves away from the transmitter because of
tilting
maximum single-hop distance limitation
interference from the sky waves
loss of line-of sight condition

⇒ The voltage e₀ in the fi
48 V
24 V
36 V
28 V

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ The reading of the voltmeter V in figure should be __________ v
60
10
66
0

⇒ The feedback control system shown in the given figure repres
Type 0 system
Type 1 system
Type 2 system
Type 3 system

⇒ A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is
1
0.7
0.2
1.4

⇒

Match the following:

	List I		List II
A.	Reactance theorem	1.	Foster
B.	Driving point impedance	2.	Bartlett
C.	Continued fraction expansion	3.	Cauer
D.	Bisection Theorem	4.	Positive real function

A-1, B-4, C-3, D-2
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ Which of the following devices uses a helix?
Klystron amplifier
Klystron oscillator
TWT
Both (a) and (b)

⇒ For the system in the given figure the root l
is on real axis between points s = -1 and s = -3.6
is on real axis between points s = 0 and s = -1
is on real axis between points s = -3.6 and s = ∞
is on real axis between points s = 0 and s = -3.6

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ In Z_RC(s) has a pole at s = 0, the first element in second Foster realization is
R
C
R and C in series
R and C in parallel

⇒

Match the following:

	List I (DOS commands)		List II (Meaning)
A.	ATTRIB	1.	Displays all directories and subdirectories
B.	SCAN DISK	2.	Moves files to another director
C.	MOVE	3.	Checks the status of disc
D.	TREE	4.	Hides a file

A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1

⇒ The range of values of a and b for which the linear time invariant system with impulse respon
|a| > 1, |b| > 1
|a| < 1, |b| < 1
|a| < 1, |b| > 1
|a| > 1, |b| < 1

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ Evaluate the power stored in inductor and capac
25 J, 12.5 J
12.5 J, 25 J
25 J, 50 J
12.5 J, 50 J

⇒ The maximum power handling capacity of a resistor depends on
total surface area
resistance value
thermal capacity of the resistor
resistivity of the material used in the resistor