Question is ⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is, Options are ⇒ (A) 2 f, (B) f, (C) 0.5 f, (D) 0.25 f, (E) , Leave your comments or Download question paper.

Question is ⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is, Options are ⇒ (A) 2 f, (B) f, (C) 0.5 f, (D) 0.25 f, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is
A.	2 f [Wrong Answer]
B.	f [Correct Answer]
C.	0.5 f [Wrong Answer]
D.	0.25 f [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The units of resistivity are ohm-metre.
TRUE
FALSE

⇒ In a semiconductor material. The hole concentration is found to be 2 x 2.5 x 10¹⁵ cm^-3. If mobility of carriers is 0.13 m²/ v-s. Then find the current density if electric field intensity is 3.62 x 10^-19
7.6237 x 10^-4 A/cm²
7.6237 x 10^-5 A/cm²
7.6237 x 10^-3 A/cm²
none of these

⇒ In a CD player the speed of CD is
constant at 500 rpm
constant at 200 rpm
varies from 200 to 500 rpm
none of the above

⇒ A dynamometer wattmeter is connected in ac circuit. The measured power is
rms power
average power
peak power
instantaneous power

⇒ Accumulator is an 8 bit register and is also known as register B.
TRUE
FALSE

⇒ The phase velocity v in a transmission line is
LC
C/L
L/C
1/LC

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε₀. The surface charge density on the conductor is ((ε₀ = 10^-9/36p)F/m)
0 c/m²
2 c/m²
1.8 x 10^-11 c/m²
1.14 x 10^-9 c/m²

⇒ In frequency modulation noise can be further reduced by
increasing deviation
reducing deviation
reducing carrier frequency
increasing signal amplitude

⇒ Which of the following is not an omnidirectional antenna?
Log periodic
Half-wave dipole
Discone
Marconi

⇒ It is required to measure a low magnitude high frequency current. The proper instrument is
moving iron
dynamometer
thermocouple
induction

⇒ A circuit said to be lumped when physical dimensions of all the component are __________ .
greater compared with wavelength of electromagnetic signal
small compared with wavelength electromagnetic signal
negligible compared with wavelength of electromagnetic signal
equal compared with wavelength of electromagnetic signal

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ Consider the following statements

Fading of signals is generally greatest near radio horizon.
Fading of signals is generally greatest in shadow zone.
Fading is small when a good optical path is present.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒

Assertion (A): Conductors do not permit propagation of waves more than a short distance into the conductor at microwave frequencies.

Reason (R): The relaxation time constant for conductors is much small than the period of centimetric EM wave.

Both (A) and (R) are true and (R) is the correct explanation of (A)
Both (A) and (R) are true but (R) is not the correct explanation of (A)
(A) is true but (R) is false
(A) is false but (R) is true

⇒ A hertzian dipole has a radiation pattern with
a null in the direction of the dipole
a null in the plane perpendicular to the dipole
a peak in the direction of the dipole
none of the above

⇒ In fibre optics the use is made of thin glass fibres for efficient transmission of light.
TRUE
FALSE

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively

⇒ Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
0
2
3
5

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7

⇒ In 8085 eight address and data buses are multiplexed.
TRUE
FALSE

⇒ The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

Program counter
Processor register
Certain status conditions

Select the correct answer using the codes given below :
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ Two capacitors of 1 μF and 2 μF are connected in series across a 10 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
10 μC each
20 μC each
10 μC and 20 μC
20 μC and 10 μC

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ The load impedance Z_L of a CE amplifier has R and L in series. The phase difference between output and input will be
180°
0
more than 90° but less than 180°
more than 180° but less than 270°

⇒ Which of the following is the digital system?
PWM
PAM
PPM
PCM

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
a few μV
about 100 μV
a few μV
a few volts

⇒ So-called 'grounded' antennas are often found insulated from the ground electrically.
TRUE
FALSE

⇒ Two port circuits are connected in parallel. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters

⇒ If the frequency of a wave 20 Hz, the time period is
20 secs
2 secs
0.2 secs
0.05 secs

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter