Question is ⇒ A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then the voltage across each resistor is, Options are ⇒ (A) half, (B) doubled, (C) increase by 4 times, (D) no change, (E) , Leave your comments or Download question paper.

Question is ⇒ A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then the voltage across each resistor is, Options are ⇒ (A) half, (B) doubled, (C) increase by 4 times, (D) no change, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then the voltage across each resistor is
A.	half [Wrong Answer]
B.	doubled [Wrong Answer]
C.	increase by 4 times [Wrong Answer]
D.	no change [Correct Answer]
View Answer 5 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following flip-flop do not have race problem?
T flip-flop
D flip-flop
JK flip-flop
Master-slave flip-flop

⇒ A n-channel JFET has I_DSS = 2 mA, Gate to source voltage V_GS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .
- 2 V
2 V
- 4 V
4 V

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ The leads in a TRIAC are denoted by
anode cathode, gate
T₁ T₂, gate
T₁, T₂, anode
T₁, T₂, T₃

⇒

Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.

Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ A FET
has two P-N junctions
has three P-N junctions
depends on the variation of the depletion layer width with reverse voltage, for its operation
depends on the variation of a magnetic field for its operation

⇒ In a thyristor the gate lead is connected to the n layer near the p layer to which anode is connected.
TRUE
FALSE

⇒ Dynamic memory cells are constructed using
FETs
MOSFETs
Transistors
Flip flops

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Human body cannot sustain electric current beyond
1 μA
10 μA
5 μA
35 μA

⇒ For the discrete time system of the given fig
y_k - 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k - 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k

⇒ Out of 5 M x 8, 1 M x 16, 2 M x 16 and 3M x 8 memories, which memory can store more bits?
5 M x 8
2 M x 16
3 M x 8
1 M x 16

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒ In tape recorders the hissing noise is due to irregularities in magnetic coating on tape.
TRUE
FALSE

⇒ In computers the size of secondary memory is usually much larger than that of primary memory.
TRUE
FALSE

⇒ End fire coupler is formed
when two equal radiators are operated in phase quadrature at a distance of λ/4 apart
when two equal radiators are operated in parallel at a distance of λ/4 apart
when two equal radiators are operated in phase quadrature at a distance of λ/2 apart
none of the above

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ In figure, V₁ = 40 V when R = 10 Ω, if R = 0, V₂ wil
40 V
30 V
20 V
10 V

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ In controlled heating circuits, thyristors act as
rectifier
inverter
ac regulator
chopper

⇒ Satellites used for international communication are called
cossort
domsat
marisat
intelsat

⇒ The ac collector current is nearly equal to
ac base current
ac signal current
ac supply current
ac emitter current

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ Q of a coil

increases with Q increasing frequency
varies linearly with frequency
increase with increasing frequency because R increases at high frequency
decrease after the peak frequency because R increases at H.F. the correct statements are

A, B
C, D
A, C
B, D

⇒ DVD uses
Laser beam for both recording and playback
Laser beam for recording and video head for playback
Video head for recording and laser beam for playback
None of the above

⇒ Thermal noise has a power spectral density which is quite uniform upto frequencies in the order of
100 Hz
10⁶ Hz
10⁹ Hz
10¹³ Hz

⇒ Carbon resistances are used in very high values.
TRUE
FALSE

⇒ Consider the frequency modulated signal 10 cos (2p x 10⁵t + 5 sin (2p x 1500t) + 7.5 sin (2p x 1000t) with carrier frequency of 10⁵Hz. The modulation index is
12.5
10
7.5
5