Question is ⇒ For NOR gate SR flip-flop, the 'no change' condition is, Options are ⇒ (A) S = 0, R = 0, (B) S = 1, R = 0, (C) S = 0, R = 1, (D) S = 1, R = 1, (E) , Leave your comments or Download question paper.

Question is ⇒ For NOR gate SR flip-flop, the 'no change' condition is, Options are ⇒ (A) S = 0, R = 0, (B) S = 1, R = 0, (C) S = 0, R = 1, (D) S = 1, R = 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For NOR gate SR flip-flop, the 'no change' condition is
A.	S = 0, R = 0 [Correct Answer]
B.	S = 1, R = 0 [Wrong Answer]
C.	S = 0, R = 1 [Wrong Answer]
D.	S = 1, R = 1 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statem
1 alone
2 alone
3 alone
1 and 3

⇒

Assertion (A): A branch with no current through it can be replaced by an open circuit or short circuit.

Reason (R): Reciprocity theorem is applicable only if the circuit has one source.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common-emitter short-circuit current gain is
1
199
99
9.9

⇒ A conductor in x-y plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m² is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these

⇒ The resistance R_AB in the circui
10 Ω
12 Ω
9 Ω
3 Ω

⇒ To evaluate X = (A + B + 1.2) * (A + B - C) the sequence of operation is
+ + + - * =
* + + + - =
+ + - * + =
- + + + * =

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ In a Gunn diode oscillator drift velocity of electron is 10⁷ cm/s and active region length is 10 x 10^-4 cm. The natural frequency of oscillation is
1 MHz
10 MHz
1 GHz
10 GHz

⇒ Find the maximum power that can be delivered to a
0.025 W
2.5 W
2.5 W
0.25 W

⇒ In figure, the magnitude
must be more than that of V_a
must be more than that of V_b
must be more than that of V_a or V_b
can be equal to or less than or more than that of V_a or V_b

⇒ A 1000 kHz carrier is simultaneously modulated by 300 Hz and 2 kHz audio sine wave. Which of the following frequencies will not be present in the output?
998 kHz
999.7 kHz
1000.3 kHz
700 kHz

⇒ Which of the following transformers has low primary current?
Current transformer
Potential transformer
Distribution transformer
Both (a) and (b)

⇒ One eV = 1.602 x 10^-19 joules.
TRUE
FALSE

⇒ Negative feedback in amplifier
reduces gain
increases frequency and phase distortion
reduces bandwidth
increases noise

⇒ Which of the following circuits can be used as parallel-to-series converter?
Digital counter
Decoder
Demultiplexer
Multiplexer

⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ The unit of ∇ x H is
Ampere
Ampere/meter
Ampere/m²
Ampere-meter

⇒ Twelve resistance each 2 ohm are connected to form a cube, one resistance being in each arm of cube. The resistance between any two diagonally opposite comers is
1 Ω
2 Ω
4 Ω
8 Ω

⇒ In CE amplifier
input and output are in phase
phase difference between input and output is 30° to 90°
phase difference between input and output is 60° to 120°
output is inverted with respect to its input voltage

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ The problem of current lagging is associated with
DCTL gates
DTL gates
ECL gates
CMOS gates

⇒ Which of the following is not a valid logical expression in Pascal?
A > = B
A < = B
A = < B
A < > B

⇒ Which of the following devices uses a slow wave structure?
Klystron two cavity amplifier
Klystron multicavity amplifier
Reflex klystron oscillator
TWT

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒ With respect to the following 555 timer circuit what will be the value of R_A and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_f = 1.4 V, Vo _on = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω

⇒ In narrowband FM, the modulation index is
near unity
about 100
about 0.1
about 300

⇒ The output of a Mealy system is 1 if there has been a pattern of 11000, otherwise 0. The minimum state for this system is :
4
5
6
7

⇒ Consider the resonant circuit as shown b
R = 10⁴ L = 5 μH C = 20 pF
1000 L = 50 μH C = 200 pF
10 K L = 50 μH C =20 pF
None of these

⇒ In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
TRUE
FALSE

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math