Question is ⇒ When a material is in superconducting state and a magnetic field is applied, Options are ⇒ (A) the superconducting property is not affected, (B) the superconducting property may be affected and resistivity may increase from zero to a low value, (C) the superconducting property may be destroyed, (D) the material may become an insulator, (E) , Leave your comments or Download question paper.

Question is ⇒ When a material is in superconducting state and a magnetic field is applied, Options are ⇒ (A) the superconducting property is not affected, (B) the superconducting property may be affected and resistivity may increase from zero to a low value, (C) the superconducting property may be destroyed, (D) the material may become an insulator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a material is in superconducting state and a magnetic field is applied
A.	the superconducting property is not affected [Wrong Answer]
B.	the superconducting property may be affected and resistivity may increase from zero to a low value [Wrong Answer]
C.	the superconducting property may be destroyed [Correct Answer]
D.	the material may become an insulator [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

Match the following:

	List I		List II
A.	Sky wave	1.	parasitic elements
B.	Antenna feed	2.	delta match
C.	Reflector	3.	long-wire antenna
D.	Rhombic antenna	4.	ionosphere

A-1, B-3, C-4, D-2
A-2, B-1, C-3, D-4
A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3

⇒ Compact discs use
magnetic recording and retrieval
optical recording and retrieval
optical recording but magnetic retrieval
magnetic recording but optical retrieval

⇒ In a circuit of figure, V_s = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power facto
0.3
0.4
0.6
none

⇒ A thermistor is a
thermocouple
thermometer
miniature resistance
heat sensitive explosive

⇒ A single phase semiconverter has a freewheeling diode. If the firing angle is a and the load is purely resistive, the periods of conduction and freewheeling respectively are
p - a and 0
p - a and a
p + a and 0
p + a and a

⇒ Donor energy level is n type semiconductor is very near valence band.
TRUE
FALSE

⇒ In a photo emissive device and emission efficiency is increased by
coating the cathode ray by an active materials
coating the cathode by an insulating material
heating the cathode
cooling the anode

⇒ Calculate the directivity of a given linear end fire, uniform array of 20 element, each separated by λ/3
100
10
26.66
30

⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is
3 L + 9 M
1.5 L + 3 M
3 L + 3 M
3 L + 6 M

⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top

⇒ Troposphere is the upper part of the Earth's atmosphere which absorbs large quantities of Sun's radiations.
TRUE
FALSE

⇒ Directive gain of elementary doublet is
100
10
1.5
0.5

⇒ A transmission line has primary constants R, L, G and C and secondary constant z₀ and γ = (a + Jβ). If the line is loss less, then
R = 0, G ≠ 0, and a = 0
R = 0, G = a, 0 and β = |r|
G = 0, a = β
R = 0, G = 0, a = 0, β = |r|

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE₁₀ mode is
1.5 x 10⁸ m/s
5.5 x 10⁸ m/s
3.46 x 10⁸ m/s
0.18 x 10⁷ m/s

⇒ A magnetic circuit has an iron length of 20 cm and air gap length 0.1 cm. If μ_r = 200 then
mmf for iron and air gap are equal
mmf for iron is much less than that for air gap
mmf for iron is much more than that for air gap
either (a) or (c)

⇒

Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Photoconductive devices uses
metallic conductors
good quality insulators
semiconductors
either (a) or (c)

⇒ The following circuit is implementation of:

sum of full adder

carry of half adder

difference of full subtractor

1 only
3 only
2 only
1 and 2 both

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

Assertion (A): CE amplifier is the most widely used BJT amplifier

Reason (R): CE amplifier has zero phase difference between input and output

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In parallel in-parallel out shift register all bits are loaded and read simultaneously.
TRUE
FALSE

⇒ Consider the following stateme
1 and 2 only
1, 2 and 4
2 and 3 only
2, 3 and 4

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
a straight line parallel to Y axis in 4th quadrant
a straight line parallel to X axis in 4th quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ Each instruction in assembly language program has the following fields:

Lable field
Mnemonic field
Operand field
Comment field

The correct sequence of these fields is?
1, 2, 3, 4
1, 2, 4, 3
2, 1, 3, 4
2, 1, 4, 3

⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
1200 Ω
2400 Ω
3600 Ω
7200 Ω

⇒ The dual of quantity charge is
current
Voltage
flux
dΦ/dt

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 076
0.3, 0.95